NEC MA431-MPi4E SDM Installation Manual English
NEC MA431-MPi4E Manual
 |
View all NEC MA431-MPi4E manuals
Add to My Manuals
Save this manual to your list of manuals |
NEC MA431-MPi4E manual content summary:
- NEC MA431-MPi4E | SDM Installation Manual English - Page 1
Installation Manual Option Board MultiSync M series, P series, MA series - NEC MA431-MPi4E | SDM Installation Manual English - Page 2
About the Symbols To ensure safe and proper use of the product, this manual uses a number of symbols to prevent injury to you and others as well you to electric shock, fire, or other risks. Refer all servicing to qualified service personnel. Do not use the product if it has structural damage. - NEC MA431-MPi4E | SDM Installation Manual English - Page 3
with this product, please contact NEC. For all other cases, please 6 to use a trained service person. 7 Failure to stand or other mounting accessory for support. • M491/M551/M651/MA491/MA551 MA431/MA491/MA551/P435/P495/P555, four or more people for the M651. Please refer to the instructions - NEC MA431-MPi4E | SDM Installation Manual English - Page 4
to a wall using a cord or chain that can support the weight of the product in order to prevent the the product. Please refer to the table top stand manual. The product may fall causing personal injury. • floor/wall in accordance with the installation instructions. A product set may fall, causing - NEC MA431-MPi4E | SDM Installation Manual English - Page 5
cabinet or use your product near water. 12 Immediately turn off the power and unplug your product from the wall outlet, then refer servicing to qualified service personnel. It may cause an electric shock or start a fire. Do not use flammable gas sprays to remove dust when cleaning the product - NEC MA431-MPi4E | SDM Installation Manual English - Page 6
CAUTION Handling the power cord. Handle the power cord with care. Damaging the cord could lead to fire or electric shock. • When connecting the power cord to the product's AC IN terminal, make sure the connector is fully and firmly inserted. • Fasten the power cord to the product by attaching the - NEC MA431-MPi4E | SDM Installation Manual English - Page 7
Please use this power cord under 125 V power supply. NOTE: This product can only be serviced in the country where it was purchased. China 220 Japan 100 MultiSync is a trademark or registered trademark of NEC Display Solutions, Ltd. in Japan and other countries. Intel and the Intel logo are - NEC MA431-MPi4E | SDM Installation Manual English - Page 8
main power switch. 2. Place the monitor face down on a flat even surface that is larger than the monitor screen. Use a sturdy table that can easily support the weight of the monitor. NOTE: To avoid scratching the LCD panel, always place a soft cloth, such as a blanket that is larger than the - NEC MA431-MPi4E | SDM Installation Manual English - Page 9
Intel® SDM-L: Remove SLOT COVER a and b (Figure 1). Slide the CENTER RAIL to the right and remove it. Reverse the process to reattach it (Figure 1-1). SLOT COVER Figure 1 Figure 1-1 4. Insert the Option Board into the monitor and affix it in place with the removed screws (Figure 2). (Recommended
-
1 -
2 -
3 -
4 -
5 -
6 -
7 -
8
-
9
 |
 |
Installation Manual
Option Board
MultiSync M series, P series, MA series