NEC UN552V Video Wall Installation Guide
NEC UN552V Manual
 |
View all NEC UN552V manuals
Add to My Manuals
Save this manual to your list of manuals |
NEC UN552V manual content summary:
- NEC UN552V | Video Wall Installation Guide - Page 1
Guide NEC Display Solutions Video Wall Installation Guide Settings and Adjustments for MultiSync® UN552S | UN552VS | UN552 | UN552V | UN492S | UN492VS | UN462A | UN462VA A guide to trouble-free, efficient video wall installation This guide will assist you in setting up your video wall quickly and - NEC UN552V | Video Wall Installation Guide - Page 2
NEC Display Solutions Video Wall Installation Guide 2. Connect remote IR sensor (KT-RC3) Used for controlling monitors via network management system (e.g. NEC - SLOT2 CH SELECT - TMDS. Note that not all OPS devices support this internal connection. DISPLAY 1 DISPLAY 2 DISPLAY 1 DISPLAY 2 HDMI - NEC UN552V | Video Wall Installation Guide - Page 3
Address assignment NEC Display Solutions Video Wall Installation Guide 8. Auto ID / IP RESET There are two options, "Auto" or "Manual" for IP chapter "Primary monitor input/output mapping" at the beginning of this guide. 11. Auto TileMatrix Setup Auto-configuration to distribute the input signal - NEC UN552V | Video Wall Installation Guide - Page 4
NEC Display Solutions Video Wall Installation Guide Additional PC-less advanced calibration capabilities Out of the Box . For further details please refer to the Display Wall Calibrator application users manual. Corner Uniformity Correction To perform the corner color matching on a single - NEC UN552V | Video Wall Installation Guide - Page 5
useful settings and application NEC Display Solutions Video Wall Installation Guide FRAME COMP and REVERSE SCAN https://www.necdisplay.com/support-and-services/naviset-administrator/overview. WITHOUT FRAME COMP WITH FRAME COMP This document is © Copyright 2019 NEC Display Solutions of
-
1 -
2 -
3 -
4 -
5
 |
 |
A guide to trouble-free, efficient
video wall installation
This guide will assist you in setting up your video wall quickly and correctly in order
to benefit fully from the specially designed video wall features. Please read the
instructions carefully and consider all the steps in order to achieve the best results.
Attention: For unboxing and physical monitor handling, please refer to the printed
Installation Manual included in each display carton box.
Video Wall Installation Guide
Settings and Adjustments for MultiSync® UN552S | UN552VS | UN552 |
UN552V | UN492S | UN492VS | UN462A | UN462VA
Guide
NEC Display Solutions
AUTO SETUP Principle
Any input signal up to UHD/30 resolution via DisplayPort, HDMI or OPS can be distributed
across the video wall by using the Tile Matrix function. The UNxx2 displays provide
several “AUTO SETUP” functions for simple and fast video wall setup and management.
To enable these functions to operate correctly, it is necessary for DisplayPort, HDMI and
LAN cables to be daisy chained as illustrated below.
Primary monitor - input/output mapping
For uncompromising visual results, no signal conversion is necessary. Refer to the
mapping table between input and output interfaces. Depending on the required input
source, use HDMI and/or DisplayPort Daisy Chain cabling.
PRIMARY
MONITOR
ID: 1
ID: 2
ID: 3
ID: 6
ID: 5
ID: 4
ID: 7
ID: 8
ID: 9
HDMI
OPS
DisplayPort
LAN
Media Player
HDMI OUT
INPUT
DisplayPort OUT
OUTPUT
DisplayPort1
OPS SLOT2 (DisplayPort)
HDMI1
DVI
OPS SLOT2 (HDMI)
Integrated Media Player
UNxx2/UXxx2 DAISY CHAIN: INPUT / OUTPUT MAPPING