Netgear GC110P Installation Guide

Installation Guide

4.

To check the port connections from the switch to the powered-on devices

that you connected, do the following:

•

Make sure that the Ethernet cables are plugged in correctly.

•

Check the left LED for each port on the switch.

The left port LED lights solid green to indicate a valid connection

to a

powered-on device and blinks green to indicate traffic on this port.

3. Configure the Switch

1.

On your mobile device or tablet, connect to the same network as the switch.

2.

Open the NETGEAR Insight app and log in to your account.

3.

Connect your mobile device to the WiFi network of the access point that is

connected to the switch.

For initial configuration, you must use local WiFi access. After you complete

initial configuration and discover the switch, you can use cloud access if the

switch is connected to the Internet.

4.

Open the NETGEAR Insight app on your mobile device.

5.

Tap

LOG IN

and enter your credentials.

6.

Click the

+

sign in the upper right corner to create a new network/location.

7.

Name your network and specify a device admin password that applies to all

the devices that you add to this network.

NETGEAR Insight Managed

8-Port Gigabit Ethernet Smart Cloud Switch

with 2 SFP Fiber Ports (GC110)

8-Port Gigabit Ethernet PoE Smart Cloud Switch

with 2 SFP Fiber Ports (GC110P)

Package Contents

•

Switch model GC110 or GC110P

•

Power adapter (varies by region)

•

Wall-mount screw kit for wall installation

•

Four rubber footpads for tabletop installation

•

Installation guide

•

Category 5e (Cat 5e) flat Ethernet cable

1. Register With the NETGEAR Insight App

Use the NETGEAR Insight App to create your network topology, set up,

configure, and monitor your switch, register your switch, activate your warranty,

and access support.

1.

On your iOS or Android mobile device or tablet, visit the app store, search

for NETGEAR Insight, and download the latest version of the app.

2.

Open the NETGEAR Insight app.

3.

If you did not set up a NETGEAR account, tap

Create NETGEAR Account

and follow the onscreen instructions.

4.

Enter the email address and password for your account and tap

LOG IN

.

2. Connect the Switch

During initial setup, you must connect the switch to a network that you can access

with a local WiFi connection to use the NETGEAR Insight app, or to the Internet

to use the Insight Cloud Portal.

For Gigabit connections, use Category 5e (Cat 5e) or higher-rated Ethernet

cables terminated with RJ-45 connectors. To use an SFP port, you must insert a

1G SFP transceiver module (available from NETGEAR).

1.

Connect devices to the network ports on the switch.

2.

Connect the switch to the network.

3.

Power on the switch and wait for two or three minutes.

•

The Power LED lights green, indicating that the switch completed its

startup process and is available on the network.

•

The switch receives an IP address from a DHCP server (or a router that

functions as a DHCP server) in your network. If your network does not

include a DHCP server, the switch uses 192.168.0.239 as its default IP

address.

Sample Connections

Front panel

Rear panel

(model GC110P)

Insight

Note:

For mounting instructions, see the hardware installation guide, which you

can download from

https://www.netgear.com/support/

.

Internet

Cloud access

Switch

Local WiFi access

Network

Router or

gateway

PoE WiFi access points

PoE VoIP phone

Continued on the other side.

Netgear GC110P Installation Guide

Netgear GC110P Manual

Netgear GC110P manual content summary: