Netgear WG602v2 WG602v2 User Manual - Page 51

Reference Manual for the WG602 v2 54 Mbps Wireless Access Point How to Configure a WG602 v2 as a Point-to-Point Bridge Wireless PC Card in a Notebook Computer Router 192.168.0.1 LAN Segment 1 AP1 ETHER N ET Point-to-Point Mode Figure 5-3: Wireless Point-to-Point Bridging AP2 Point-to-Point Mode Hub or Switch Wireless PC Card in a Notebook Computer LAN Segment 2 Note: The 54 Mbps Wireless Access Point WG602 v2 bridging and repeater modes are only compatible with the NETGEAR WG602v2 and the NETGEAR WG302 Wireless Access Points. 1. Verify the following parameters for all access points: • Verify that the LAN network configuration of the WG602 v2 Access Points are configured to operate in the same LAN network address range as the LAN devices • If using DHCP, all WG602 v2 Access Points should be set to "Obtain an IP address automatically (DHCP Client)" in the IP Address Source portion of the Basic IP Settings menu. • If MAC access control list security is enabled on the APs, verify that the MAC access control lists on each AP are complete for the entire network and accurate. • All WG602 v2 Access Points use the same SSID, Channel, WEP authentication mode, if any, and encryption in use (WPA is not available in bridge modes). • All Point-to-Point APs must have AP2's MAC address in its Remote AP MAC address table. You can locate the MAC address in the Information page of each WG602 v2. Advanced Configuration 5-3 M-10181-03