Netgear WNCE2001-100NAS WNCE2001 Install Guide

Universal WiFi Internet Adapter

(WNCE2001)

Power

Package Contents

Power

Ethernet

LAN

Top and Back Views

Power

WLAN

Reset

button

WPS

LED

LED

LED

Port

USB power

cable

Ethernet cable

WNCE2001

adapter

Installation with WPS

Step 2:

Wait until the Power LED on

Step 3:

Push the WPS button on your router. The WLAN LED

Step 1:

Connect the WNCE2001

on the WNCE2001 will stay green for

5 seconds when the wireless connection has been

established.

to your TV, XBox, or Blu-ray

player using the Ethernet

cable (included) and one

of the power connection

options. For more information

on power-up methods,

see “Power Connection

Options” on the reverse side.

the

WNCE2001

is

solid

green. Push the WPS button on

the WNCE2001. The WLAN

LED will blink amber and

green, showing that the WPS is

running.

Step 4:

Congratulations! Your installation is complete.

What is WPS?

If you have a NETGEAR router, this feature is called Push ‘N’ Connect. Look for the

or

symbols on the router to make sure

the NETGEAR router supports WPS. For non-NETGEAR routers, please refer to the user manual to determine if the router supports WPS.

Once you know whether your router supports WPS, choose the appropriate installation method below.

WPS (WiFi Protected Setup) is a simple and secured way to connect a device to an existing network.

Installation without WPS

Step 1:

Please disconnect any wireless connection to the router and/or

remove the Ethernet cable currently connected to the computer.

You may restore the connection after the WNCE2001 installation

is complete.

Step 2

:

Connect the WNCE2001 to your computer, using the Ethernet

cable (included) and one of the power connection options.

For more information on power-up methods, see “Power

Connection Options” on the reverse side.

Step 3:

Wait until both the Power and LAN LEDs are solid green.

Make sure the computer gets the IP address. Then, open

your Internet browser and it will automatically take you

to the setup page. Follow the instructions on the setup page,

then return to this guide and continue to

Step 4.

Step 4:

Disconnect the Ethernet and USB cables from your computer.

Step 5:

Connect the WNCE2001 to your TV, Box, or Blu-ray player.

If your device doesn’t have a USB port, see “Power

Connection Options” on the reverse side.

Step 6:

Congratulations! Your installation is complete.

NOTE

: Make sure you go through the connection settings on your TV, XBox, or Blu-ray player after the

WNCE2001 is configured and connected. If asked for the type of connection, make sure

WIRED

is selected.