Netgear XSM7224S APS300W Installation Guide

Installation Guide

Replacing an APS300W Power Supply

Removing an APS300W Power Supply

To remove the APS300W power module, follow these steps:

1.

Disconnect the power cord from the power module.

2.

Remove the power cord from the power connector.

3.

Loosen the two captive screws on the power module.

4.

Remove the power module from the power module slot by pulling on the

extraction handle.

Installing an APS300W Power Supply

To install an APS300W power module, follow these steps:

WARNING!!

When inserting a power module into the switches, do not use

unnecessary force. Doing so can damage the connectors on the rear of the

supply and on the midplane.

1.

Insert the new power supply module into the power module slot, and gently

push the module into the slot.

2.

Align the two captive screws with the screw holes in the switch’s back panel.

3.

Using a screwdriver, gently tighten the captive screws.

4.

Insert the AC power cord into the power module and connect the power cord to

an AC outlet.

Specifications

Specifications

Dimensions (HxWxD)

1.60" x 4.90" x 9.00"

(40.6 x 124.4 x 228.6mm)

Weight

2.82 lb (1.28kg)

Operating Temperature

32 to 122 ºF (0 to 50 ºC)

Storage Temperature

-49 to 185 ºF (-45 to 85 ºC)

Operative relative humidity

10 to 90% and non condensing

MTBF

938,490 Hours (~107 years) @ 25ºC

421,664 Hours (~48 years) @ 50 ºC

ProSafe

®

Auxiliary Power Supply APS300W

The ProSafe

®

Auxiliary Power Supply APS300W provides a replaceable power

supply for the XSM7224S 10 Gigabit Switch. The XSM7224S Switch supports dual

APS300W power supplies, so you can make use of another APS300W while

replacing the failed power supply. Refer to the switch Hardware Installation Guide

for additional information. When another APS300W is used, the failed APS300W

can be replaced without stopping the switch or requiring a reboot.

APS300W_IG_2Nov10.fm

Page 1

Friday, November 12, 2010

10:37 AM