Nikon P80 P80 User's Manual - Page 149
Cleaning, Storage, Notes on the Monitor, Notes on Smear
View all Nikon P80 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 149 highlights
Caring for the Camera Cleaning Lens/ electronic viewfinder Avoid touching glass parts with your fingers. Remove dust or lint with a blower (typically a small device with a rubber bulb attached to one end that is pumped to produce a stream of air out the other end). To remove fingerprints or other stains that cannot be removed with a blower, wipe the lens with a soft cloth, using a spiral motion that starts at the center of the lens and working toward the edges. If this fails, clean the lens using a cloth lightly dampened with commercial lens cleaner. LCD monitor Remove dust or lint with a blower. To remove fingerprints and other stains, clean the LCD monitor with a soft, dry cloth, being careful not to apply pressure. Body Use a blower to remove dust, dirt or sand, then wipe gently with a soft, dry cloth. After using the camera at the beach or seaside, wipe off any sand or salt with a dry cloth lightly dampened with fresh water, then dry thoroughly. Note that foreign matter inside the camera could cause damage not covered by the warranty. Do not use alcohol, thinner, or other volatile chemicals. Storage Turn the camera off when not in use. Check that the power-on lamp is off before putting the camera away. Remove the battery if the camera will not be used for an extended period. Do not store the camera with naptha or camphor moth balls, or in any of the following locations: • Next to equipment that produces strong electromagnetic fields, such as televisions or radios • Exposed to temperatures below -10 °C (14 °F) or above 50 °C (122 °F) • Poorly ventilated or subject to humidities of over 60 % To prevent mold or mildew, take the camera out of storage at least once a month. Turn the camera on and release the shutter a few times before putting the camera away again. Technical Notes C Notes on the Monitor • The monitor may contain a few pixels that are always lit or that do not light. This is a characteristic common to all TFT LCD displays, and does not indicate a malfunction. Images recorded using the product will not be affected. • Images in the monitor may be difficult to see under bright lighting. • The monitor is lit by an LED backlight. Should the monitor begin to dim or flicker, contact your Nikon-authorized service representative. C Notes on Smear When framing bright subjects, vertical comet-like streaks that whiten toward either end may appear in the display. This phenomenon, known as "smear," does not indicate a malfunction. In shooting modes other than high-speed continuous or movie, smear has no effect on the images that are recorded. When using the high-speed continuous shooting and movie modes, however, we recommend that you avoid shooting bright objects. 135