Oki C7300 C7100/C7300/C7500 - Install Procedures for Transfer Belt
Oki C7300 Manual
 |
View all Oki C7300 manuals
Add to My Manuals
Save this manual to your list of manuals |
Oki C7300 manual content summary:
- Oki C7300 | C7100/C7300/C7500 - Install Procedures for Transfer Belt - Page 1
Transfer Belt Replacement Instructions Transfer Belt Part Number: 41945501 Caution! The fuser unit (at the back of the printer) may be HOT. Let it cool down before attempting to replace the transfer belt. 1. Turn off the printer. 2. Pull up on the handle and lift the cover. transfer belt unit - Oki C7300 | C7100/C7300/C7500 - Install Procedures for Transfer Belt - Page 2
the original packaging be determined by Oki Data to be defective, it will be repaired or replaced, at Oki Data's option, at no charge to the also have other rights which vary from state to state. Oki Data Service Centers United States Oki Data Americas, Inc. 2020 Bishops Gate Blvd. Mt. Laurel, NJ
-
1 -
2
 |
 |
C7100/7300/C7500
Transfer Belt
Replacement Instructions
Transfer Belt Part Number: 41945501
58364401
Caution! The fuser unit (at the
back of the printer) may be HOT.
Let it cool down before attempting
to replace the transfer belt.
1.
Turn off the printer.
2.
Pull up on the handle and lift the
cover.
3.
Lift out the drum/toner cradle.
4.
Press back on the lock lever
(circled) and, while holding the
lock lever, lift the end of the
transfer belt unit up by the blue
handle (squared).
5.
Grasp both handles and lift the
transfer belt unit out of the printer.
Discard in accordance with local
regulations.
Caution! Make sure the blue lock
levers at either end of the fuser
have snapped back locking the
fuser unit in place. If not, pull them
toward the front of the printer.
6.
Unpack the new transfer belt unit.
Caution! Be careful to avoid touch-
ing the shiny black surface of the
transfer belt.
7.
Hold the transfer belt by the
handles and lower it into the
printer, carefully aligning the pins
at the front of the belt into the slots
at the front of the printer.
8.
Using the blue handle, firmly push
the unit into place until it clicks.
If
necessary, pull the blue lock lever
(circled) toward the front of the
printer to lock the transfer belt into
place.
9.
Place the drum/toner cradle back
into the printer.
10. Close the cover and turn on the
printer.