Oki ML421 Network User's Guide for OkiLAN 6020e - Page 189

EtherTalk Section 6 - Chapter 2 - The OkiLAN 6020e Utility Enable Port This option allows you to enable or disable a port. If a port is disabled, it will appear in the OkiLAN 6020e utility but will not appear in the Chooser. A disabled port cannot be configured. The only valid options for a disabled port are Status, Enable Port, Print Config, and Restore Defaults. A port should be disabled when no printer is attached. Note: It is possible to disable all ports but this is not recommended. The EtherTalk protocol will still be active on the network. To disable the EtherTalk protocol, use a utility from one of the other protocols. Reset Board This option will reset the print server. Restore Defaults This option will automatically return the EtherTalk interface to its factory defaults. All ports will be restored to factory defaults. The following OkiLAN 6020e variables will restore to default: Name: OKI Port (for single port products, the port number will not be shown) Type 1 = LaserWriter Type 2 = (None) Zone = Default - (The default zone for the network segment will be used) Port Enabled = Yes OKI OkiLAN 6020e User's Guide VI - 7