Olympus STYLUS TOUGH-6020 STYLUS TOUGH-3000 Instruction Manual (English) - Page 69

settings. Channel: CH1, Group: A, Set [REMOTE FLASH] p. 37 - waterproof camera

Page 69 highlights

Taking pictures with the Olympus Wireless RC Flash System STYLUS TOUGH-8010/μ TOUGH-8010 only You can take pictures with a wireless flash when using a flash compatible with the Olympus Wireless RC Flash System. This enables multi-flash photography using multiple flash units compatible with this system. The camera's built-in flash is used for communication between the camera and flash. For details about operation of a wireless flash, refer to the instruction manual for the special external flash. 1 Set the wireless flash based on the guidelines below. Wireless flash setup range guidelines The setup range varies depending on the ambient environment. Point the remote sensor toward the camera Flash direction 30° 50° 50° 5m 30° 10m 2 Turn on the wireless flash. 3 Use the MODE button on the wireless flash to set to RC mode, and make the channel and group settings. (Channel: CH1, Group: A) 4 Set [REMOTE FLASH] (p. 37) on the camera to [#RC], and set the channel to the same setting as the wireless flash. 5 Select the flash mode. "Using the flash" (p. 28) 6 Take a test shot to check the operation of the flash and the resulting image. Be sure to check the charge level of the camera and wireless flash before taking pictures. Although there is no limit on the number of wireless flash units that are set up, usage of a maximum of three units is recommended to prevent malfunction due to interference with each other. When the camera flash is set to [#RC], the camera built-in flash is used for communication with the wireless flash. It cannot used for taking pictures. Important information about water and shock resistant features Water resistance: The waterproof feature is warranted to operate at the following depths for up to one hour. STYLUS TOUGH-8010/μ TOUGH-8010: 10 m (32.8 ft.) STYLUS TOUGH-6020/μ TOUGH-6020: 5 m (16.4 ft.) STYLUS TOUGH-3000/μ TOUGH-3000: 3 m (9.8 ft.) The waterproof feature may be compromised if the camera is subject to substantial or excessive impact. Shock resistance: The anti-shock feature warrants*2 the operation of the camera against accidental impact incurred from everyday use of your digital compact camera. The anti-shock feature does not unconditionally warrant all defective operation or cosmetic damage. Cosmetic damage, such as scratches and dents, are not covered under the warranty. EN 69

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
  • 53
  • 54
  • 55
  • 56
  • 57
  • 58
  • 59
  • 60
  • 61
  • 62
  • 63
  • 64
  • 65
  • 66
  • 67
  • 68
  • 69
  • 70
  • 71
  • 72
  • 73
  • 74
  • 75
  • 76
  • 77
  • 78
  • 79
  • 80
  • 81
  • 82
  • 83

69
EN
Taking pictures with the
Olympus Wireless RC Flash
System
STYLUS TOUGH-8010/
Μ
TOUGH-8010 only
You can take pictures with a wireless
ash
when using a
ash compatible with the Olympus
Wireless RC Flash System. This enables
multi-
ash photography using multiple
ash
units compatible with this system. The camera’s
built-in
ash is used for communication between
the camera and
ash.
For details about operation of a wireless
ash, refer to the instruction manual for the
special external
ash.
1
Set the wireless
ash based on the
guidelines below.
Wireless
ash setup range guidelines
The setup range varies depending on the
ambient environment.
5m
50°
50°
10m
30°
30°
50°
50°
30°
30°
Point the remote
sensor toward
the camera
Flash direction
2
Turn on the wireless
ash.
3
Use the MODE button on the
wireless
ash to set to RC mode,
and make the channel and group
settings. (Channel: CH1, Group: A)
4
Set [REMOTE FLASH] (p. 37) on
the camera to [
#
RC], and set the
channel to the same setting as the
wireless
ash.
5
Select the
ash mode.
“Using the
ash” (p. 28)
6
Take a test shot to check the
operation of the
ash and the
resulting image.
Be sure to check the charge level of the
camera and wireless
ash before taking
pictures.
Although there is no limit on the number of
wireless
ash units that are set up, usage of
a maximum of three units is recommended
to prevent malfunction due to interference
with each other.
When the camera
ash is set to [
#
RC],
the camera built-in
ash is used for
communication with the wireless
ash. It
cannot used for taking pictures.
Important information about
water and shock resistant
features
Water resistance:
The waterproof feature is
warranted to operate at the following depths for
up to one hour.
STYLUS TOUGH-8010/
Μ
TOUGH-8010:
10 m (32.8 ft.)
STYLUS TOUGH-6020/
Μ
TOUGH-6020:
5 m (16.4 ft.)
STYLUS TOUGH-3000/
Μ
TOUGH-3000:
3 m (9.8 ft.)
The waterproof feature may be compromised if
the camera is subject to substantial or excessive
impact.
Shock resistance:
The anti-shock feature
warrants
*2
the operation of the camera against
accidental impact incurred from everyday use
of your digital compact camera. The anti-shock
feature does not unconditionally warrant all
defective operation or cosmetic damage.
Cosmetic damage, such as scratches and dents,
are not covered under the warranty.