Onkyo AS-140 Instruction Manual
Onkyo AS-140 Manual
 |
View all Onkyo AS-140 manuals
Add to My Manuals
Save this manual to your list of manuals |
Onkyo AS-140 manual content summary:
- Onkyo AS-140 | Instruction Manual - Page 1
STAND AS-140 Instruction Manual Thank you for purchasing the Onkyo speaker stand. Please read this manual thoroughly before using it. Keep this manual for future reference. Cautions 1. Be sure to tighten the screws when you assemble the speaker stands and attach the speaker stands to the speakers - Onkyo AS-140 | Instruction Manual - Page 2
in the base panel will align. Tighten the screws firmly. Pipe stand Pull the cable out about 3" (8 cm.) Note: You can also wire the speaker cables without passing them through the pipe stands. Screws (small, × 2) Align. 4 Guide the speaker cable along the arrow on the base panel bottom, and snap - Onkyo AS-140 | Instruction Manual - Page 3
tape that you attached in Step 1. (1) Insert the hook on the pipe stand into the key hole on the speaker's rear panel, then (2) press and slide the speaker downward. (2) Press and slide the speaker downward. Specifications Dimensions (W × H × D): 10-5/8" × 35-3/16" × 10-5/8" (270 × 894 × 270 mm - Onkyo AS-140 | Instruction Manual - Page 4
Sales & Product Planning Div. : 2-1, Nisshin-cho, Neyagawa-shi, OSAKA 572-8540, JAPAN Tel: 072-831-8023 Fax: 072-831-8124 ONKYO U.S.A. CORPORATION 18 Park Way, Upper Saddle River, N.J. 07458, U.S.A. Tel: 201-785-2600 Fax: 201-785-2650 http://www.us.onkyo.com/ ONKYO EUROPE ELECTRONICS GmbH
-
1 -
2 -
3 -
4
 |
 |
E
n
SPEAKER STAND
AS-140
Instruction Manual
Thank you for purchasing the Onkyo speaker stand.
Please read this manual thoroughly before using it.
Keep this manual for future reference.
1.
Be sure to tighten the screws when you assemble the speaker stands and attach the speaker stands to the speakers.
2.
The speaker stands are tall. Install the stands in a manner that will not allow the speakers to tip over. You may want
to use commercially available chains to prevent the stands from falling in the event of an earthquake.
3.
Do not place the stands on an unstable table, slope, or thick carpet. Otherwise, the stands may fall, causing injury.
4.
Place the stands in a location in which they would not cause injury if they accidentally fell.
5.
Do not place the stands in an area at risk of fire or damage, such as near a fireplace, heater, glass window, etc.
Note:
Speaker cables are not included in this package.
Cautions
Supplied Accessories
•
Screws (large) [2]
•
Screws (small) [4]
•
Pipe stands [2]
•
Base panels [2]