Onkyo HT-R530 Owner Manual - Page 50

)54@&OCPPL 1BHF  .POEBZ 'FCSVBSZ 1. Advanced Setup-Continued Digital Input Signal Formats The following table shows the display indicators for each supported digital signal format. Format Dolby Digital DTS PCM Display PCM Normally, the AV receiver detects the signal format automatically. However, if you experience either of the following issues when playing PCM or DTS material, you can manually set the signal format to PCM or DTS: • If the beginnings of tracks from a PCM source are cut off, try setting the format to PCM. • If noise is produced when fast forwarding or reversing a DTS CD, try setting the format to DTS. STANDBY/ON A SPEAKERS B PHONES TUNING / PRESET STANDBY ENTER PURE AUDIO TONE MULTl CH + DVD STEREO LISTENING MODE DISPLAY DIGITAL INPUT RT/PTY/TP MEMORY TUNING MODE RETURN SETUP CLEAR VIDEO 1 VIDEO 2 VIDEO 3 TAPE TUNER CD VCR MASTER VOLUME VIDEO 3 INPUT VIDEO L AUDIO R DIGITAL INPUT 1 Press and hold the AV receiver's [DIGITAL INPUT] button for about 3 seconds. 2 While "Auto" is displayed (about 3 seconds), press the [DIGITAL INPUT] button again to select: PCM, DTS, or Auto. DTS or PCM: The DTS or PCM indicator, depending on which format you have set, flashes, and only signals in that format are output. Digital signals in other formats are ignored. Auto (default): The format is detected automatically. If no digital input signal is present, the corresponding analog input is used instead. 50