Onkyo HT-R530 Owner Manual - Page 52

)54@&OCPPL 1BHF  .POEBZ 'FCSVBSZ 1. Controlling Other Components You can use the AV receiver's remote controller (RC-608M) to control your other components, including 2 those made by other manufacturers. This chapter explains how to enter the necessary remote control code for the component that you want to control (e.g., DVD player, TV, or VCR). While holding down the REMOTE MODE button that you want to set, press the [DISPLAY] button for 3 seconds. The REMOTE MODE button lights up. Entering Remote Control Codes Entering a remote control code for each REMOTE MODE button allows you to control your other components with the remote controller. You'll need to perform this procedure for each component that you want to control. RECEIVER Number buttons ON STANDBY REMOTE MODE RECEIVER DVD TAPE/AMP INPUT SELECTOR 1 2 3 V1 V2 V3 M D C D CDR 4 5 6 TV MULTI CH DVD 7 8 9 VCR TAPE TUNER C D +10 0 CLR 10 11 12 --/--- DIMMER SLEEP SAT CABLE TV VOL INPUT GUIDE TOP MENU CH DISC VOL PREVIOUS MENU SP A / B ENTER MUTING RETURN SETUP REMOTE MODE DISPLAY LISTENING MODE STEREO SURROUND AUDIO SUBTITLE RANDOM REPEAT TEST TONE CH SEL LEVEL- LEVEL+ PLAY MODE HDD DISPLAY OR-EQ L NIGHT DVD CINE FLTR RC-608M L NIGHT 1 Look up the remote control code for the component in the appro- priate category. See the separate Remote Control Codes. 3 Within 30 seconds, use the num- ber buttons to enter the 4-digit remote control code. The REMOTE MODE button flashes twice. 4 Press the REMOTE MODE button again to select the remote con- troller mode, point the remote controller at the component, and check the operation. If the remote controller works OK, the code has been entered correctly. If not, try again or try another code. Notes: • A remote control code cannot be entered for the [RECEIVER] button. • There are the only codes available at the time that this instruction manual was printed. • If the codes don't work, try using other manufacture's codes to see if it will help you preprogram your remote controller. 52