Onkyo HT-R530 Owner Manual - Page 53
Remote Control Codes for Onkyo, Components Connected via, Resetting the REMOTE MODE, Buttons,
View all Onkyo HT-R530 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 53 highlights
)54@&OCPPL 1BHF .POEBZ 'FCSVBSZ 1. Controlling Other Components-Continued Remote Control Codes for Onkyo Components Connected via Onkyo components that are connected via can be controlled by pointing the remote controller at the AV receiver. This means that you can control such components even if they are out of sight, for example, installed in a rack. 1 Make sure the Onkyo component is connected with an cable and an analog audio cable (RCA). See page 31 for details. 2 Enter the appropriate remote control code for the [DVD] or [CD] REMOTE MODE button. [DVD] REMOTE MODE button 1612: DVD player with [CD] REMOTE MODE button 1327: CD player with 1808: MD recorder with 1322: CD recorder with See the previous page for information on entering remote control codes. 3 Press the [DVD] or [CD] REMOTE MODE button, point the remote controller at the AV receiver, and operate the component. If you want to control an Onkyo component by pointing the remote controller directly at it, or you want to control an Onkyo component that's not connected via , enter the following remote control codes: [DVD] REMOTE MODE button 0627: DVD player without (default) [CD/MD/CDR] REMOTE MODE button 1817: CD player without (default) 0868: MD recorder without 1323: CD recorder without Note: If you connect an -compatible Onkyo MiniDisc or CD recorder to the TAPE IN/OUT jacks, for remote operation to work properly, you must set the display to MD or CDR (see page 33). Resetting the REMOTE MODE Buttons If you've previously entered a code for a REMOTE MODE button but now want to reset it, perform the following procedure. 1 While holding down the REMOTE MODE button that you want to reset, press the [L NIGHT] button for 3 seconds. The REMOTE MODE button lights up. 2 Press the REMOTE MODE button again. The REMOTE MODE button is reset and flashes twice. The [DVD] and [CD] REMOTE MODE buttons are preprogrammed with remote control codes for controlling Onkyo components. When one of these buttons is reset, the preprogrammed code is restored. Resetting the Remote Controller You can reset the remote controller to its default settings. 1 While holding down the [RECEIVER] button, press the [L NIGHT] button for 3 seconds. The [RECEIVER] button lights up. 2 Press the [RECEIVER] button again. The remote controller is reset and the [RECEIVER] button flashes twice. 53