Onkyo HT-RC440 Owner Manual - Page 54

Remote Control Codes for Onkyo Components Connected via RI Onkyo components that are connected via V are controlled by pointing the remote controller at the AV receiver, not the component. This allows you to control components that are out of view, in a rack, for example. 1 Make sure the Onkyo component is connected with an V cable and an analog audio cable (RCA). See "Connecting Onkyo RI Components" for details (➔ page 16). 2 Enter the appropriate remote control code for a REMOTE MODE button, by referring to the previous section. ` 42157: Onkyo cassette tape deck with V ` 81993: Onkyo Dock with V 3 Press the REMOTE MODE button, point the remote controller at the AV receiver, and operate the component. Controlling Onkyo components without V If you want to control an Onkyo component by pointing the remote controller directly at it, or you want to control an Onkyo component that's not connected via V, use the following remote control codes: ` 30627: Onkyo DVD player without V ` 71817: Onkyo CD player without V ` 32900/33100/33500: Onkyo Blu-ray Disc player ` 32901/33104/33504: Onkyo HD DVD player ` 70868: Onkyo MD recorder without V ` 71323: Onkyo CD recorder without V ` 82990: Onkyo Dock without V Resetting the REMOTE MODE Buttons You can reset a REMOTE MODE button to its default remote control code. 1 While holding down the REMOTE MODE button that you want to reset, press and hold down HOME until the remote indicator lights (about 3 seconds). 2 Within 30 seconds, press the REMOTE MODE button again. The remote indicator flashes twice, indicating that the button has been reset. Each REMOTE MODE button is preprogrammed with a remote control code. When a button is reset, its preprogrammed code is restored. Resetting the Remote Controller You can reset the remote controller to its default settings. 1 While holding down RECEIVER, press and hold down HOME until the remote indicator lights (about 3 seconds). 2 Within 30 seconds, press RECEIVER again. The remote indicator flashes twice, indicating that the remote controller has been reset. Controlling Other Components Controlling Other Components By pressing the REMOTE MODE button that's been programmed with the remote control code for your component, you can control your component as described below. For details on entering a remote control code for other components, see "Entering Remote Control Codes" (➔ page 53). Controlling a TV TV is preprogrammed with the remote control code for controlling a TV that supports the Q*1 (limited to some models). The TV must be able to receive remote control commands via Q and be connected to the AV receiver via HDMI. If controlling your TV via Q doesn't work very well, program your TV's remote control code into TV and use the TV remote mode to control your TV. Use the following remote control codes: ` 11807/13100/13500: TV with Q Controlling Apple TV By programming the supplied remote controller with the appropriate remote control code, you can use it to operate your Apple TV. Use the following remote control codes: ` 02615: Apple TV En-54