Onkyo HT-S3500 Owner Manual - Page 50
Controlling Other Onkyo Components, Preprogrammed Remote Control Codes, Entering Remote Control Codes - rack
View all Onkyo HT-S3500 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 50 highlights
Controlling Other Onkyo Components You can use the AV receiver's remote controller to control your other Onkyo AV components. This section explains how to enter the remote control code for a component that you want to control: DVD, CD, etc. Preprogrammed Remote Control Codes The following REMOTE MODE butttons are preprogrammed with remote control codes for controlling the components listed. You do not need to enter a remote control code to control these components. For details on controlling these components, see the indicated pages. BD/DVD Onkyo Blu-ray Disc player (➔ page 52) TV/CD Onkyo CD player (➔ page 53) Entering Remote Control Codes You'll need to enter a code for each component that you want to control. 1 Look up the appropriate remote control code in the Remote Control Codes for Onkyo Components Connected via V. 2 While holding down the REMOTE MODE button to which you want to assign a code, press and hold down DISPLAY (about 3 seconds). The remote indicator lights. Note • Remote control codes cannot be entered for RECEIVER. • Except for RECEIVER remote control codes from any category can be assigned to the REMOTE MODE button. However, these buttons also work as input selector buttons (➔ page 21), so choose a REMOTE MODE button that corresponds with the input to which you connect your component. For example, if you connect your CD player to the CD input, choose TV/CD when entering its remote control code. 3 Within 30 seconds, use the number buttons to enter the 5-digit remote control code. The remote indicator flashes twice. If the remote control code is not entered successfully, the remote indicator will flash once slowly. Controlling Other Components Remote Control Codes for Onkyo Components Connected via V Onkyo components that are connected via V are controlled by pointing the remote controller at the AV receiver, not the component. This allows you to control components that are out of view, in a rack, for example. 1 Make sure the Onkyo component is connected with an V cable and an analog audio cable (RCA). See "Connecting Onkyo V Components" for details (➔ page 18). 2 Enter the appropriate remote control code for a REMOTE MODE button, by referring to the previous section. ` 42157: Onkyo cassette tape deck with V ` 81993: Onkyo Dock with V 3 Press the REMOTE MODE button, point the remote controller at the AV receiver, and operate the component. To be continued En-50