Onkyo HT-S6300 Owner Manual - Page 50

Note • The "Power Control" setting can be set only when the "HDMI Control (RIHD)" setting is set to "On". • HDMI power control only works with Q-compatible components that support it and may not work properly with some components due to their settings or compatibility. • When set to "On", power consumption will increase. • When set to "On", regardless of whether the AV receiver is On or in Standby, both audio and video stream from an HDMI input will be output to the TV or other components via HDMI connection (HDMI pass through function). When the HDMI pass through function activates in standby mode, HDMI THRU indicator will light. • The power consumption during standby mode will increase during the HDMI pass through function; however if your TV supports CEC (Consumer Electronics Control), the power consumption can be saved in the following cases: 1. The TV is in standby mode. 2. You are watching a TV program. • Refer to the connected component's instruction manual for details. ■ TV Control ` Off: TV Control disabled. ` On: TV Control enabled. Set to "On" when you want to control the AV receiver from an Q-compatible TV that is connected to HDMI. Note • Do not assign the component connected with the HDMI input to the TV/CD selector when you set "TV Control" setting to "On". Otherwise, appropriate CEC (Consumer Electronics Control) operation is not guaranteed. • Set to "Off" when the TV is not compatible or when it is unclear whether the TV is compatible or not. • The "TV Control" setting can be set only when the "HDMI Control (RIHD)" (➔ 49) and "Power Control" (➔ 49) settings are both set to "On". • Refer to the connected component's instruction manual for details. After changing the settings of the "HDMI Control (RIHD)", "Audio Return Channel", "Power Control", or "TV Control", turn off the power to all connected pieces of equipment and then turn them on again. Refer to the user's manuals for all connected pieces of equipment. Lock Setup With this preference, you can protect your settings by locking the setup menus. Main menu Lock Setup ■ Setup ` Locked: Setup menus locked. ` Unlocked: Setup menus not locked. When the setup menus are locked, you cannot change any setting. Using the Audio Settings You can change various audio settings by pressing AUDIO (➔ 26). 1 Press RECEIVER followed by AUDIO. 2 UseR/X to select "Audio", and then use R/X/F/S to make the desired selection. Note • These settings are disabled when: - a pair of headphones is connected, or - the "Audio TV Out" setting is set to "On" ( ➔ 49) and an input selector other than HDMI is selected. Tone Control Settings You can adjust the bass and treble for the front speakers, except when the Direct listening mode is selected. ■ Bass ` -10dB to 0dB to +10dB in 2 dB steps. You can boost or cut low-frequency sounds. ■ Treble ` -10dB to 0dB to +10dB in 2 dB steps. You can boost or cut high-frequency sounds. Operating on the AV receiver 1 Press TONE on the AV receiver repeatedly to select either "Bass" or "Treble". 2 Use TONE LEVEL +/- on the AV receiver to adjust. En 50