Onkyo TX-DS575x Owner Manual - Page 31

Using the remote controller Overview When you use a remote controller, typically you press one of the MODE buttons that corresponds to the device you wish to control, then press the operation buttons. For example, if you wish to control the TX-DS575X from a remote controller, first press the MODE AUDIO button, then press an appropriate operation button. To control a CD player, press the MODE CD button, then press an appropriate operation button. First, press the desired MODE button to make sure that the TX-DS575X is set to a correct mode. SEND/LEARN indicator ON MODE AUDIO ON SLEEP MODE AUDIO DISPLAY CH +/- STNBY STNBY LIGHT VOL TEST MUTING Using the RC-392M to control each device Turning the power on and off to the TX-DS575X Note: Before operating the RC-392M, turn on the POWER switch on the TX-DS575X so that the unit enters standby mode. 1. Press the MODE AUDIO button. 2. Pressing the ON button will power on. Pressing the STNBY button will power standby. SEND/LEARN indicator This indicator acts as a guide when commands are programmed into or sent by the remote controller. It also warns the user when an error is made or battery power is low. Controlling the TX-DS575X 1. Press the MODE AUDIO button. 2. Press the desired operation button. Shaded buttons in the figure are the operation buttons used to control the TX-DS575X. SLEEP : Sleep function ON/STNBY : Power on/standby DISPLAY : Changing the display VOL q/u : Adjusting the volume CH +/- : Tuner preset number increment/decrement INPUT SELECTOR Listening mode (STEREO/DSP√/DSP®/SURROUND) : Changing Listening mode SP A/SP B : Switching between Speakers A and B CH SEL : Selecting a speaker DIMMER : Adjusting the brightness of the display LEVEL +/- : Adjusting the speaker levels TEST : Test tone MUTING : Muting LIGHT : Iluminating the buttons. INPUT SELECTOR SP A/B Listening mode LEVEL +/- DIMMER CH SEL 31