Onkyo TX-DS575x Owner Manual - Page 7

Video equipment connections • On each pair of input jacks, a red connector (marked R) corresponds to the right channel, and a white connector (marked L) to the left channel. • A yellow connector (marked V) is used for video connection. • Please refer to the instruction manual of each component when making any con- nections. Audio connection cable L (Left) L R (Right) R Video connection cable V (Video) V AUDIO OUTPUT VIDEO OUTPUT S-VIDEO OUTPUT DVD Player DIGITAL COAXIAL OUTPUT DIGITAL OPTICAL OUTPUT Digital audio connections This receiver has a powerful digital signal processor for use with DVD players, DAT decks, and CD players. The digital inputs, COAXIAL 1, 2 and OPTICAL1, 2 can be assigned to individual input selector buttons, so when an input selector button is pressed, the assigned digital input is used instead of the corresponding analog input. (See page 18.) ANTENNA WARNING AVIS RISK OF ELECTRIC SHOCK RISQUE DE CHOC ELECTRIQUE DO NOT OPEN NE PAS OUVRIR R L V L S DVD I N AM VIDEO 3 R I N L FRONT SPEAKERS A R VIDEO 2 FM 75 GND VIDEO 1 L R PHONO CD (PLAY) I N TAPE OUT (REC) R V L I N CENTER SPEAKER I N FRONT OUT R L MONITOR OUT SURROUND S R L SUBWOOFER PRE OUT CENTER SUB WOOFER MULTI CH INPUT DIGITAL INPUT COAXIAL 2 FRONT SPEAKERS B COAXIAL 1 L OPTICAL 2 OPTICAL 1 R SURROUND SPEAKERS L R REMOTE CONTROL AC OUTLETS AC 230V 50Hz SWITCHED TOTAL 100W MAX. AV RECEIVER MODEL NO. TX-DS575X : signal flow AUDIO OUT AUDIO IN VIDEO OUT S-VIDEO OUT S-VIDEO IN VIDEO IN Video Cassette Recorder S-VIDEO IN VIDEO IN Monitor TV S-VIDEO OUT VIDEO OUT AUDIO OUT VDP Player Notes: • When using a playback-only VCR, connect it to VIDEO 2 or VIDEO 3. If you connect it to VIDEO 1, you need to make only the out- put connections. • This receiver can be used with only a monitor TV equipped with a video input jack. • Interference may be caused between the TV and this receiver. If this interference occurs, place the receiver and the TV as far apart as possible. We do not recommend the use of a common TV/FM antenna (see antenna section). • A DVD or other component equipped with a digital output can be connected to this receiver. The digital connection must be used in conjunction with an analog connection, because if the analog cable is disconnected, the audio output from TAPE OUT (REC) and VIDEO 1 OUT will not work. • A signal input from the S-video connector will be routed to the S-video out, and the signal input from the video connector will be routed to the video out. • Refer to the instruction manual for the devices you wish to connect for information on whether you need to connect only the S-video connector, or both S-video connector and video connector. • Remove the protective cap attached to the DIGITAL INPUT (OPTICAL) jack before making the connection. When this jack is not used, replace the protective cap. 7