Optoma EP737 User Manual
Optoma EP737 Manual
 |
View all Optoma EP737 manuals
Add to My Manuals
Save this manual to your list of manuals |
Optoma EP737 manual content summary:
- Optoma EP737 | User Manual - Page 1
the Projector 9 Powering On/Off the Projector 10 Powering On the Projector 10 Powering Off the Projector 11 Adjusting the Projected Image 12 Adjusting the Projector Height 12 Adjusting the Projector Zoom/Focus 13 Adjusting Projection Image Size 13 User Controls Panel Control & Remote Control - Optoma EP737 | User Manual - Page 2
user’s guide remote control is equipped with a Class II laser that emits radiation. Warning- When the lamp reaches the end of its life, it will burn out and may make a loud popping sound. If this happens, the projector will not turn back on until the lamp module has been replaced. To replace the lamp - Optoma EP737 | User Manual - Page 3
English Usage Notice Do: v Turn off the product before cleaning. v Use a soft cloth moistened with mild detergent to clean the display housing. v Disconnect the power plug from AC outlet if the product is not being used for a long period of time. Don’t: v Block the slots and openings on the unit - Optoma EP737 | User Manual - Page 4
‹ User friendly multilingual on-screen display menu ‹ Advanced electronic keystone correction and high quality full screen re-scaling image ‹ User friendly control panel ‹ Luxurious carrying case included ‹ SXGA compression and VGA, SVGA re-sizing ‹ 150 Watts user replaceable P-VIP lamp ‹ Mac - Optoma EP737 | User Manual - Page 5
dealer immediately if anything is missing. Projector with lens cap RS232 Cable Power Cord S-Video Cable Audio Cable Composite Video Cable M1-A to VGA and USB cable Battery x 2 Remote Control with Mouse Function and Laser Pointer User's Guide Carrying Case Quick Start Card Warranty Card - Optoma EP737 | User Manual - Page 6
English Introduction Product Overview Main Unit 7 5 4 8 9 10 6 3 1. Panel Control 2. Power Connector 3. Connection Ports 4. Focus Ring 5. Zoom Lens 6. Zoom Ring 7. Speaker 8. Remote Control Receiver 9. Elevator Button 10. Elevator Foot 6 1 2 - Optoma EP737 | User Manual - Page 7
Panel Control 7 9 4 2 English Introduction 6 8 5 1 3 1. Lamp Warning LED 2. Temperature Warning LED 3. Power Indicator Light 4. Power /Standby 5. Menu (On/Off) 6. Four Directional Select Keys 7. Enter 8. Re-sync 9. Source Connection Ports 1 2 3 4 56 7 1. KensingtonTM Lock Hole 2. Monitor - Optoma EP737 | User Manual - Page 8
Mouse Function & Laser Pointer LED Power / Standby Page Down Laser Pointer Volume ( + / - ) Mute Freeze Multi-Directional Selector Re-sync Source Page Up Keystone Correction Zoom In / Zoom Out Menu vClose the cover of the remote control when you want to use the remote mouse. Caution : To reduce - Optoma EP737 | User Manual - Page 9
8 3 Video Output S-Video Output 1. RS232 Cable 2. Power Cord 3. S-Video Cable 4. Audio Cable 5. Composite Video Cable 6. M1-A to VGA and USB Cable 7. M1-A to HDTV and USB Cable (optional) 8. M1-D to DVI-D and USB Cable (optional) v To ensure the projector works well with your computer, please - Optoma EP737 | User Manual - Page 10
Powering On/Off the Projector Powering On the Projector 1. Remove the lens cap.Œ 2. Ensure that the power cord and signal cable are securely connected. 3. Turn on the lamp by pressing “Power/Standby” button on the control panel. The startup screen will be displayed for 20 seconds and the Power - Optoma EP737 | User Manual - Page 11
of the indicator flashing. 4. Disconnect the power cord from the electrical outlet and the projector. 5. Do not turn on the projector immediately following a power off procedure. v When the “TEMP” indicator flashes red for about 10 seconds, you will see a message “Fan Fail” on the on-screen display - Optoma EP737 | User Manual - Page 12
release the button to lock the elevator foot into position. 3. Use Ž to fine-tune tilt-adjustment. To lower the projector: 1. Press the elevator button. 2. Lower down the projector, then release the button to lock the elevator foot into position. 3. Use Ž to fine-tune tilt-adjustment. 1 Elevator - Optoma EP737 | User Manual - Page 13
image, rotate the focus ring until the image is clear. The projector will focus at distances from 3.74 feet to 39.37 feet (1. 123.0" 102.5" 98.40" x 73.80" 82.00" x 61.50" 16.40' vThis graph is for user’s reference only. 196.9" 246.1" 295.3" 164.0" 205.1" 246.1" 157.52" x 118.14" 196.88" x - Optoma EP737 | User Manual - Page 14
English User Controls Panel Control & Remote Control There are two ways for you to control the functions: Remote Control and Panel Control. Panel Control Remote Control Use the Remote Control Power / Standby 4 Refer to the “Power On/Off the Projector” section on page 10~11. Source 4 Press “ - Optoma EP737 | User Manual - Page 15
can be used as a mouse to control direction. ™ The above function is only enabled with the connection between computer and projector by M1-A to VGA and USB cable. When the cover of remote control is opened, this key can be used for the operation for OSD display. Page Up (Computer mode only - Optoma EP737 | User Manual - Page 16
English User Controls Enter 4 Confirm your selection of items, when you open the front cover of remote control. 4 If the remote control cover is closed, the Enter button functions like the left mouse button. Use the Panel Control Power/Standby 4 Refer to the “Power On/Off the Projector” section - Optoma EP737 | User Manual - Page 17
English User Controls On-Screen Display Menus How to operate 4The Projector has multilingual On-Screen Display( OSD will be the “ Video OSD”. The projector will detect the source automatically. 4To open the OSD menu, press the “Menu” button on the Remote Control or Panel Control. 4 When OSD is - Optoma EP737 | User Manual - Page 18
English User Controls Computer mode Language Management Image-I Image-II PIP Audio Brightness Zoom Contrast Keystone Color Temp. Low White Segment High Image-I (Computer mode) Brightness Adjusting - Optoma EP737 | User Manual - Page 19
Video mode Language Management Image-I Image-II Audio Brightness Tint Contrast Sharpness Color White Segment English User Controls Image-I (Video mode) Brightness Adjusting the brightness of the image. 4 Press the 4 Press the Contrast to darken the image. to lighten the image. The - Optoma EP737 | User Manual - Page 20
English User Controls Video mode Language Management Image-I Image-II Audio Brightness Tine Contrast Sharpness Color White Segment Image-I (Video mode) White Segment Use the white segment - Optoma EP737 | User Manual - Page 21
English User Controls Computer mode Language Management Image-I Image-II PIP Audio Frequency H. Position Tracking V. Position 16:9 / 4:3 Reset Yes No Image-II (Computer mode) vReset : Reset items - Optoma EP737 | User Manual - Page 22
English User Controls Video mode Language Management Image-I Image-II Audio Keystone 16:9 / 4:3 Color Temp. Low High Reset Yes No Image-II (Video mode) Keystone Correction Adjust image distortion caused by tilting the projector. (±16 degrees) 16 : 9 / 4 : 3 You can use this function to - Optoma EP737 | User Manual - Page 23
Computer / Video mode Language Management Image-I Image-II PIP Audio Volume Stereo / Mono Treble Mute Bass English User Controls Audio vThe OSD does not include a PIP menu under Video mode. Volume 4 Press the 4 Press the Treble to decrease the volume. to increase the - Optoma EP737 | User Manual - Page 24
English User Controls Computer / Video mode Image-I Image-II Language Management Audio PIP Language Language You can display the multilingual OSD menu . Use the and key to select your prefered language. vThe OSD does not include a PIP menu under Video mode. 24 - Optoma EP737 | User Manual - Page 25
you select this function, the projector reverses and turns the image upside down at same time. You can project from behind a translucent screen with ceiling mounted projection. Signal Type Select signal type between RGB, HDTV and Component video sources. Lamp Reminding Choose this function to - Optoma EP737 | User Manual - Page 26
English User Controls Computer mode Image-I Language Size Off Position Image-II Management screen position on the display screen. Source Choose the input source of the projector. 4Auto : Automatically synchronizes the projector to the input source. 4 : Select the input source to Composite - Optoma EP737 | User Manual - Page 27
English Appendices Troubleshooting If you are experiencing trouble with the projector, refer to the following. If the problem persists, please contact your local reseller or service center. Problem : No image appears on screen. 4 Ensure all the cables and power connections are correctly and securely - Optoma EP737 | User Manual - Page 28
” or “CRT only” mode. 4 If you are experiencing difficulty in changing resolutions or your monitor freezes, restart all the equipment and the projector. Problem : The screen of the Notebook or PowerBook computer is not displaying your presentation. 4 If you are using Notebook PC: Some Notebook PCs - Optoma EP737 | User Manual - Page 29
the projection. Problem : Lamp burns out or makes a popping sound 4 When the lamp reaches its end of life, it will burn out and may make a loud popping sound. If this happens, the projector will not turn back on until the lamp module has been replaced. To replace the lamp, follow the procedures - Optoma EP737 | User Manual - Page 30
the Power/ Standby button. 2. Allow the projector to cool down at least 30 minutes. 3. Disconnect the power cord. 4. Use screwdriver to remove the screw from the cover.Œ 5. Remove the cover. 6. Remove the 2 screws from the lamp module.Ž 7. Pull out the lamp module. To replace the lamp module - Optoma EP737 | User Manual - Page 31
Distance Video Compatibility H. Frequency V. Frequency Multimedia Audio Power Supply Power Consumption Noise level I/O Connectors Dimensions (W x H x D) Environmental Safety Regulation - Single Chip DLPTM Technology - 150W User Replaceable P-VIP Lamp - 1024 pixels(H) X 768 lines(V) - 16.7M colors - Optoma EP737 | User Manual - Page 32
English Appendices Compatibility Modes Remark : “*” compression computer image. Mode VESA VGA VESA VGA VESA VGA VESA VGA VESA VGA VESA VGA VESA VGA VESA VGA VESA VGA SVGA SVGA SVGA SVGA SVGA VESA XGA VESA XGA VESA XGA VESA XGA VESA XGA * VESA SXGA * VESA SXGA MAC LC13" MAC II 13" MAC 16" MAC 19"
-
1 -
2 -
3 -
4 -
5 -
6 -
7 -
8
-
9
-
10
-
11
-
12
-
13
-
14
-
15
-
16
-
17
-
18
-
19
-
20
-
21
-
22
-
23
-
24
-
25
-
26
-
27
-
28
-
29
-
30
-
31
-
32
 |
 |
1
E
nglish
Usage Notice
Precautions
........................................................................................................
2
Introduction
Product Features
...............................................................................................
4
Package Overview
.............................................................................................
5
Product Overview
...............................................................................................
6
Main Unit
......................................................................................................
6
Panel Control
................................................................................................
7
Connection Ports
..........................................................................................
7
Remote Control with Mouse Function & Laser Pointer
................................
8
Installation
Connecting the Projector
...................................................................................
9
Powering On/Off the Projector
...........................................................................
10
Powering On the Projector
...........................................................................
10
Powering Off the Projector
...........................................................................
11
Adjusting the Projected Image
...........................................................................
12
Adjusting the Projector Height
......................................................................
12
Adjusting the Projector Zoom/Focus
............................................................
13
Adjusting Projection Image Size
..................................................................
13
User Controls
Panel Control & Remote Control
........................................................................
14
On-Screen Display Menus
................................................................................
17
How to Operate
............................................................................................
17
Image-I (Computer mode)
............................................................................
18
Image-I (Video mode)
...................................................................................
19
Image-II (Computer mode)
...........................................................................
21
Image-II (Video mode)
..................................................................................
22
Audio
............................................................................................................
23
Language
.....................................................................................................
24
Management
.................................................................................................
25
PIP (Computer mode)
..................................................................................
26
Appendices
Troubleshooting
.................................................................................................
27
Changing the Lamp
............................................................................................
30
Specifications
.....................................................................................................
31
Compatibility Modes
...........................................................................................
32
Table of Contents