Optoma EW1610 User's Manual - Page 50
Lamp Replacement Procedure
UPC - 796435117016
View all Optoma EW1610 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 50 highlights
Appendices 1 3 5 2 4 5 Lamp Replacement Procedure: 1. Switch off the power to the projector by pressing the "Power" button. 2. Allow the projector to cool down for at least 30 minutes. 3. Disconnect the power cord. 4. Use a screwdriver to unscrew the 2 screws from the cover. 5. Push up and remove the cover. 6. Use a screwdriver to unscrew the 2 screws from the lamp module. 7. Pull up the lamp handle carefully. 8. Remove the lamp module. To replace the lamp module, follow previous steps in reverse order. 9. Turn on the projector and use "Lamp Reset" after the lamp module is replaced. Lamp Reset: (i) Press "Menu" (ii) Select "Options" (iii) Select "Lamp settings" (iv) Select "Lamp reset (v) Select "Yes". English 50
50
English
Appendices
Lamp Replacement Procedure:
1. Switch off the power to the projector by pressing the “Power” button.
2. Allow the projector to cool down for at least 30 minutes.
3. Disconnect the power cord.
4. Use a screwdriver to unscrew the 2 screws from the cover.
5. Push up and remove the cover.
6. Use a screwdriver to unscrew the 2 screws from the lamp module.
7. Pull up the lamp handle carefully.
8.
Remove the lamp module.
To replace the lamp module, follow previous steps in reverse order.
9.
Turn on the projector and use “Lamp Reset” after the lamp module is
replaced.
Lamp Reset: (i) Press “Menu”
(ii) Select “Options”
(iii) Select
“Lamp settings”
(iv) Select “Lamp reset
(v) Select “Yes”.
3
5
5
4
2
1