Oregon Scientific EMR201 User Manual 2

OVERVIEW

FRONT VIEW

1.

Remote sensor reception indicator

2.

Outdoor temperature

3.

Indoor temperature

4.

Ice alert LED indicator

BACK VIEW

1.

°C / °F

: Select temperature unit

2.

RESET

: Reset unit to default settings

REMOTE SENSOR

1.

LED

status indicator

2.

Wall mount hole

3.

Battery compartment

4.

RESET

hole

5.

CHANNEL

switch

GETTING STARTED

INSERT BATTERIES

1.

Remove the battery compartment.

2.

Insert the batteries, matching the polarities (see

FIG 2).

3.

Press

RESET

after each battery change.

Wireless Indoor and

Outdoor Thermometer

with LED Ice Alert

Model: EMR201

USER MANUAL

4

2

3

1

TEMP

TEMP

IN

OUT

�±²³´µ²¶·

RESET

C/ F

2

1

REMOTE SENSOR

To set up the sensor:

1.

Open the battery compartment (see FIG 3).

2.

Select channel 1 then press

RESET

.

3.

Close the battery door.

4.

Place the sensor within 30 m (98 ft) of the main

unit using the table stand or wall mount.

TIP

Ideal placements for the sensor would be in any

location on the exterior of the home at a height of

not more than 5 ft and which can shield it from direct

sunlight or wet conditions for an accurate reading.

NOTE

Use alkaline batteries for longer usage and

consumer grade lithium batteries in temperatures

below freezing.

SENSOR DATA TRANSMISSION

To search for a sensor:

Reset the unit.

The sensor reception icon in the remote sensor area

shows the status:

TIP

The transmission range may vary depending

on many factors. You may need to experiment with

various locations to get the best results.

ICE WARNING

If the channel 1 sensor falls between 3°C to -2 °C

(37°F to 28°F), LED indicator will flash, and will stop

flashing once the temperature is out of this range.

RESET

Press

RESET

to return to the default settings.

PRECAUTIONS

•

Do not subject the unit to excessive force,

shock, dust, temperature or humidity.

•

Do not cover the ventilation holes with any items

such as newspapers, curtains etc.

•

Do not immerse the unit in water. If you spill

liquid over it, dry it immediately with a soft,

lint-free cloth.

•

Do not clean the unit with abrasive or corrosive

materials.

•

Do

not

tamper

with

the

unit’s

internal

components. This invalidates the warranty.

•

Only use fresh batteries. Do not mix new and

old batteries.

•

Images shown in this manual may differ from

the actual display.

•

When disposing of this product, ensure it is

collected separately for special treatment.

LOCATION

MEANING

Indoor temperature

area

Outdoor temperature

area

Main unit batteries low

Sensor batteries low

ICON

DESCRIPTION

Main unit is searching

for sensor(s).

A channel has been

found.

The sensor cannot be

found.

OUT

OUT

OUT

OUT

OUT

OUT

OUT

•

Placement of this product on certain types

of wood may result in damage to its finish for

which Oregon Scientific will not be responsible.

Consult

the

furniture

manufacturer’s

care

instructions for information.

•

The contents of this manual may not be

reproduced without the permission of the

manufacturer.

•

Do not dispose old batteries as unsorted

municipal waste. Collection of such waste

separately for special treatment is necessary.

•

Please note that some units are equipped with

a battery safety strip. Remove the strip from the

battery compartment before first use.

NOTE

The technical specifications for this product

and the contents of the user manual are subject to

change without notice.

SPECIFICATIONS

ABOUT OREGON SCIENTIFIC

Visit our website (www.oregonscientific.com) to

learn more about Oregon Scientific products. If

you’re in the US and would like to contact our

Customer Care department directly, please visit:

www2.oregonscientific.com/service/support

OR

Call 1-800-853-8883.

For international inquiries, please visit:

www2.oregonscientific.com/about/international

FCC STATEMENT

This device complies with Part 15 of the FCC Rules.

Operation is subject to the following two conditions:

(1) This device may not cause harmful interference,

and (2) This device must accept any interference

received, including interference that may cause

undesired operation.

WARNING

Changes or modifications not expressly

approved by the party responsible for compliance

could void the user’s authority to operate the

equipment.

NOTE

This equipment has been tested and found

to comply with the limits for a Class B digital

device, pursuant to Part 15 of the FCC Rules. These

limits are designed to provide reasonable protection

against

harmful

interference

in

a

residential

installation.

This equipment generates, uses and can radiate

radio frequency energy and, if not installed and

used in accordance with the instructions, may cause

harmful interference to radio communications.

However, there is no guarantee that interference

will not occur in a particular installation. If this

equipment does cause harmful interference to radio or

television reception, which can be determined

by turning the equipment off and on, the user is

encouraged to try to correct the interference by one

or more of the following measures:

TYPE

DESCRIPTION

MAIN UNIT

L x W x H

241 g (8.5 oz) without battery

66 x 27.5 x 87.5 mm

(2.59 x 1.08 x 3.44 in)

Weight

Temperature range

-5°C to 50°C (23°F to 122°F)

Resolution

0.1°C (0.2°F)

Signal frequency

433 MHz

Humidity range

25% - 95%

Humidity resolution

1%

Power

2 x UM-4 (AAA)

1.5 V batteries

REMOTE UNIT (THN132N)

L x W x H

96 x 50 x 22 mm

(3.78 x 1.97 x 0.87 in)

Weight

62 g (2.22 ounces)

Transmission range

30 m (98 ft) unobstructed

Temperature range

-20°C to 60°C (-4°F to 140°F)

Power

1 x UM-3 (AA) 1.5 V batteries

·

Reorient or relocate the receiving antenna.

·

Increase the separation between the equipment

and receiver.

·

Connect the equipment into an outlet on a circuit

different from that to which the receiver is

connected.

·

Consult the dealer or an experienced radio / TV

technician for help.

DECLARATION OF CONFORMITY

The following information is not to be used as

contact for support or sales. Please call our

customer service number (listed on our website at

www.oregonscientific.com, or on the warranty card

for this product) for all inquiries instead.

We

Name:

Oregon Scientific, Inc.

Address:

19861 SW 95th Ave.,Tualatin,

Oregon 97062 USA

Telephone No.:

1-800-853-8883

declare that the product

Product No.:

EMR201

Product Name:

Wireless Indoor and Outdoor

Thermometer with LED Ice

Alert

Manufacturer:

IDT Technology Limited

Address:

Block C, 9/F, Kaiser Estate,

Phase 1,41 Man Yue St.,

Hung Hom, Kowloon,

Hong Kong

is in conformity with Part 15 of the FCC Rules.

Operation is subject to the following two conditions:

1) This device may not cause harmful interference.

2) This device must accept any interference

received, including interference that may cause

undesired operation.

© 2007 Oregon Scientific. All rights reserved.

P/N: 086L005000-011

2

3

4

5

1

Oregon Scientific EMR201 User Manual 2

Oregon Scientific EMR201 Manual

Oregon Scientific EMR201 manual content summary: