Panamax MX5102 Manual

ADDITIONAL TECHNICAL INFORMATION:

Panamax MX5102 is intended to be installed in a dry indoor environment with a maximum ambient temperature of 0 – 40°C (32 – 104°F)

and that is free of conductive contaminants.

1690 Corporate Circle, Petaluma, CA 94954

www.panamax.com

•

707-283-5900

•

Fax 707-283-5901

When replacing batteries, replace the two batteries with the following:

BB Battery, Part Number

HR1234W

, rated

12V

,

34W

CAUTION:

RISK OF ENERGY HAZARD: 12V, maximum 9 Ampere-hour batteries. Before replacing batteries, remove conductive

jewelry such as chains, wrist watches and rings. High energy through conductive materials could cause severe burns.

CAUTION:

DO NOT dispose of batteries in a fire.

The batteries may explode.

CAUTION:

DO NOT open or mutilate batteries.

Released material is harmful to the skin and eyes and may be toxic.

NOTICE TO SERVICE PERSONNEL ONLY:

INS00851-MX5102-D,

PMX ADDENDUM

Battery

EMI Filter

Surge

Suppressor

Charger

AC / DC

Inverter

Input

Output

Normal Mode

Battery Mode

SYSTEM FUNCTIONAL BLOCK DIAGRAM

RELEASE CLIP

RIGHT FRONT PANEL

Battery Replacement Procedure

1

.

Remove the grommet (A) from the right side of the right front panel then push up on the

release clip (B) and remove panel (C).

A

B

C

2

.

Remove the two screws.

B

A

C

3

.

Disconnect the cables (A) and pull battery pack

out with swivel handle (B).

4

.

In reverse order of steps 1 - 3,

slide new battery pack into the unit,

replace the screws, reconnect the

cables and replace front panel

and grommet.

5

.

Recharge the unit for 4-8 hours to ensure the

UPS performs expected runtime.

CAUTION:

To avoid electrical shock, a screwdriver must

be used to remove screws to open battery cover before

replacing battery. Must close battery compartment using

screwdriver to tighten screws.