Panasonic DMPBDT220 DMPBDT220 User Guide - Page 34
Messages, On the television, On the unit's display - remote codes
View all Panasonic DMPBDT220 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 34 highlights
Messages The following messages or service numbers appear on the television or unit's display. On the television Cannot play. ¾ You inserted an incompatible disc (Discs recorded in PAL video, etc.). Cannot display on this unit. ¾ You tried to play a non-compatible image. ¾ Confirm "SD" on the unit's display is not displayed and re-insert the card. No disc inserted. ¾ The disc may be upside down. $ This operation is not available. ¾ Some operations are unsupported by the unit. For example; - BD-Video: During playback, reverse slow-motion or reverse frame-by-frame is not possible. IP address is not set. ¾ The "IP Address" in "IP Address/DNS Settings" is Set the "IP Address", "Subnet Mask", and "Default Gateway". (Select the automatic address acquisition if necessary.) The current wireless network security setting is weak. It is recommended to change to a stronger security setting. ¾ Authentication type for the wireless LAN is set to "Open system", or the encryption type is set to "No encryption". It is recommended to encrypt for safety reasons. For details, refer to the instructions of the wireless router being used. Encryption is required when playing back video, etc., from DLNA compatible devices. On the unit's display F99 ¾ The unit fails to operate properly. Press [Í/I] on the main unit for 3 seconds to switch the unit to standby, then switch back on. HDMI ONLY ¾ Some BD-Video discs can only be output with HDMI. NET ¾ While connecting to a network. No PLAY ¾ There is a viewing restriction on a BD-Video or DVD-Video. (> 29) No READ ¾ The media is dirty or badly scratched. The unit cannot play. PLEASE WAIT ¾ The unit is carrying out an internal process. This is not a malfunction. You cannot operate the unit while "PLEASE WAIT" is displayed. REMOVE ¾ The USB device is drawing too much power. Remove the USB device. SET (" " stands for a number.) ¾ The remote control and main unit are using different codes. Change the code on the remote control. Press and hold [OK] and the indicated number button at the same time for more than 5 seconds. 34 VQT3V20