Panasonic DMREZ485V Dvd Recorder - English/spanish - Page 79
Error Messages, On the Unit's Display
View all Panasonic DMREZ485V manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 79 highlights
Error Messages On the Unit's Display H ,F (" " stands for a service number.) RC (" " stands for a number.) HARD ERR ("HArd" and "Err" are alternately displayed.) NO READ ("NO" and "REAd" are alternately displayed.) An error has occurred. The number following "H" or "F" depends on the status of the unit. Check the items below and in the Troubleshooting Guide. If the service number still does not disappear after the check, reset the unit ( 81, "To restore the unit if it freezes"). If the service numbers fail to clear, note the service numbers and contact a qualified service person. The remote control and the main unit are using different codes. Change the code on the remote control. If there is no change after turning the unit on and off, consult the dealer where the unit was purchased. The disc is dirty or badly scratched. The unit cannot record, play, or edit. The disc may be incompatible or of poor quality. You have used a lens cleaner and it has finished operation. Press [ OPEN/CLOSE] on the main unit to eject the disc. Displayed when the unit is started. This is not a malfunction. The unit is carrying out its recovery process. You cannot operate the unit while " " is displayed. FULL There are already 16 scheduled recording programs. Delete unnecessary scheduled recording programs. UNSUPPORT You have inserted a disc the unit cannot play or record on. ("UNSUP" and "POrt" are alternately You tried to operate with a non-compatible USB memory. displayed.) UNFORMAT ("UNFOr" and "MAt" are alternately displayed.) You have inserted a new DVD-RW/+RW or a DVD-RAM/DVD-RW (DVD-Video format) recorded on other equipment. You can format the disc when the format confirmation screen is displayed. " " is displayed on the unit's display. This unit is confirming that it is connected with equipment compatible with HDAVI Control. F74 The HDMI connection could not be authenticated due to a transfer malfunction. Consult the dealer where the unit was purchased. F75 The HDMI connection could not be authenticated due to an internal data malfunction. Consult the dealer where the unit was purchased. U59 The unit is very warm. The unit switches to standby for safety reasons. Wait for about 30 minutes until the message disappears. Reinstall the unit in an area with adequate ventilation. Do not block the cooling fan on the rear of the unit. U61 There was a power failure or the AC power supply cord was disconnected while the unit was on. The unit is carrying out its recovery process. This process restores the unit to normal operation. The unit is not broken. Wait until the message disappears. U72 The HDMI connection acts unusually. U73 - The connected equipment is not HDMI compatible. - Please use HIGH SPEED HDMI cables that have the HDMI logo (as shown on the cover). - The HDMI cable is damaged. U76 HDMI cannot be output because you are connected to a model that does not support copyright protection. U88 There was something unusual detected with the disc while recording, playing or copying; there was a power failure or the AC power supply cord was disconnected while the unit was on. The unit is carrying out its recovery process. This process restores the unit to normal operation. The unit is not broken. Wait until the message disappears. U99 Continued on next page. The unit fails to operate properly. Press [/I POWER] on the main unit to switch the unit to standby. Press [/I POWER] on the main unit again to turn the unit on. Page − − 57 − 75 74, 75, 76 15 − − 27 74, 75 73 25, 53 − − − 83 − 79 Reference RQT9056