Panasonic HDC-TM20K8 User Manual - Page 42
Quick start, HDC-HS20
View all Panasonic HDC-TM20K8 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 42 highlights
Quick start This unit will resume recording pause mode about 0.6 seconds after the LCD monitor is reopened. ≥ When in quick start standby mode about 60% ( / : about 70%) of the power used in recording pause mode is being consumed, so the recording time will be reduced. ¬ Change the mode to . 1 Select the menu. (l 27) [SETUP] # [QUICK START] # [ON] 2 Close the LCD monitor while the mode is set to . HDC-SD20 HDC-TM20 HDC-HS20 The status indicator A flashes green and the unit goes into quick start standby mode. ≥ The lens cover does not close. 3 Open the LCD monitor. HDC-SD20 HDC-TM20 HDC-HS20 The status indicator A lights red and the unit is put into recording pause. ≥ Quick start standby mode is cancelled if jabout 5 minutes elapsed jmode is set to junit is turned off ≥ Time for quick start will be more than 0.6 seconds slower when digital cinema is used. ≥ It may take some time for automatic white balance to adjust. ≥ In the quick start mode, the zoom magnification becomes 1k. ≥ If [ECONOMY] (l 29) is set to [5 MINUTES] and the unit automatically goes into quick start standby mode, close the LCD monitor and then open it again. ≥ Quick Start Standby Mode cannot be released by the remote control. Turn the mode to OFF when powering off. 42 VQT2B34