Panasonic KXT3250 Operating Instructions

Panasonic KXT3250 - Integrated Telephone System Manual

Get Panasonic KXT3250 - Integrated Telephone System PDF manuals and user guides
UPC - 037988455065
View all Panasonic KXT3250 manuals
Add to My Manuals
Save this manual to your list of manuals

Panasonic KXT3250 manual content summary:

  • Panasonic KXT3250 | Operating Instructions - Page 1
    KX-T3250B Telephone with Automatic Dialer and Intercom telefono con marcador autornatico e interfono • Please read before use. Le rogamos leer antes de utilizer. Operating Instructions coi. Instrucciones de operacion INTERCOM Installation Procedure Connection Preparation Basic Operation Manual
  • Panasonic KXT3250 | Operating Instructions - Page 2
    KX-T3250B to use intercom. • Up to 5 units of the KX-T3250B can be connected on the same line. Memory Card `You can also use the reverse side for writing. The instruction Button Redial Button Mute Button Mute/Memory Indicator SP-PHONE Button and Indicator Program Button Pause Button La
  • Panasonic KXT3250 | Operating Instructions - Page 3
    for installing a two lines, intercom/paging phone. Precaution: The telephone company central office line (COL) must be disconnected during the modular jack installation. Telephone Company Central Office Lines House Wiring Modular Wall Jack Tel. CO Block in Home '"KX-1 -3250B KX-T3250B - 2 -
  • Panasonic KXT3250 | Operating Instructions - Page 4
    Outlet To Telephone Line t 0 AC Adaptor or Auxiliary Jack 4 To another KX-T3250B (KX-A098) Connect to "L1/L2/INT'COW Telephone line cord (6-wire) Telephone jack must be installed the telephone company or a quali installer. Be sure to use the AC adaptor. If a power failure Accessories
  • Panasonic KXT3250 | Operating Instructions - Page 5
    Conection (cont.) INWhen a 4-wire telephone line connection (for 2-line) has been installed, make a 2-wire line connection for intercom and then connect as follows. For intercomi__ (the outer two\ \\conductors / Auxiliary Jack To Telephone Line 4. J To L1/L2/
  • Panasonic KXT3250 | Operating Instructions - Page 6
    (See below). Be sure to use the AC adaptor. If a power failure takes place, the unit can be used as a regular telephone. USE ONLY Panasonic AC ADAPTOR, KX-A09B. Confirm that the setting position of the voltage selector on the AC Adaptor is set to your household AC voltage, If not, set
  • Panasonic KXT3250 | Operating Instructions - Page 7
    HIGH, LOW, OFF Set to "HIGH". 7 LOW: The ringing sound level will be low. OFF: The Phone Unit will not ring. L1, L2 Set to "L"I" or "L2". 7 During a power failure, the unit 15 1 .• • No override. 16 An extension user cannot intrude into another extension that is in conversation. - 6 -
  • Panasonic KXT3250 | Operating Instructions - Page 8
    Preparation (cont.) INT'COM L2 I L1 Set to "HIGH" on each ringer volume selector. HIGH ••• The ringing sound level will be high. LOW ••• The ringing sound level will be low. OFF ••• No ringing sound.
  • Panasonic KXT3250 | Operating Instructions - Page 9
    Manual Outward Dialing and Receiving BASIC OPERATION You can program the Line 2) will be selected when you lift the handset or push the SP-PHONE button. Dialing Hands-free: 1. O0 SP-PHONE Push SP-PHONE. •The SP-PHONE indicator will light. Using the handset: 1. Lift the handset. 2. EIBEI
  • Panasonic KXT3250 | Operating Instructions - Page 10
    BASIC OPERATION Manual Outward Dialing and Receiving (cont.) TO DIAL THROUGH THE DESIRED Dialing 1. Lift the handset or push SP-PHONE button. 2. Push the LINE button whose indicator is off. 3. Dial the phone number. 4. Hang up the handset or push SP-PHONE button. RECEIVING When an outside call is
  • Panasonic KXT3250 | Operating Instructions - Page 11
    Lift the handset. •The SP-PHONE indicator will go out. Handset to Hands-free 1. SP-PHONE Push SP-PHONE. • The SP-PHONE indicator will light. 2. Replace If you replace the handset on the cradle before pushing the SP-PHONE button, the conversation will be terminated. Helpful Hints • When the
  • Panasonic KXT3250 | Operating Instructions - Page 12
    (up to 16 digits). 5. PROGRAM After storing all the numbers, push PROGRAM. • The MEMORY indicator will go out. II Using the Lower memory location: Another phone number can be stored into the Lower memory section of the Same Direct Call button. In this case, you must change step 2 of the storing
  • Panasonic KXT3250 | Operating Instructions - Page 13
    one that was previously stored. Repeat the procedure of storing. ERASING A STORED NUMBER Be sure that the handset is on the cradle, the SP-PHONE button is off and the AC adaptor is connected. 1. PROGRAM Push PROGRAM until the MEMORY indicator lights. 2. Push the DIRECT CALL button. 0 (Or push
  • Panasonic KXT3250 | Operating Instructions - Page 14
    Programming Station programming must be done on each extension which is connected in parallel. Be sure that the handset is on the cradle, the SP-PHONE button is off and the AC adaptor is connected. AUTOMATIC LINE SELECTION (WHEN GOING OFF-HOOK) This feature allows you to automatically select the
  • Panasonic KXT3250 | Operating Instructions - Page 15
    Station Programming (cont.) EXTENSION NUMBER ASSIGNMENT To make or receive an intercom call assign an extension number at each KX-T3250B. 1. PROGRAM Push PROGRAM for about one second. 2. DBE MOO 1:1E -] Push "1", "2", "3", "4" or "5" on the dial pad. •"1" ••• To assign number 1. •"2" ••• To
  • Panasonic KXT3250 | Operating Instructions - Page 16
    STATION PROGRAMMING Station Programming (cont.) INTERCOM ALERTING TYPE SETTING The intercom alerting type (Bell/Voice) at a receiving extension can be programmed. BELL: Bell alerting sound at the receiving extension. C VOICE: Voice alerting is heard through the built-in speaker on the
  • Panasonic KXT3250 | Operating Instructions - Page 17
    Station Programming (cont.) EXECUTIVE OVERRIDE (Barge-In) Allows you to intrude into another extension that is in conversation with an outside party. 1. Push PROGRAM. PROGRAM 2. MUTE Push MUTE. 3. Push "1" or "2". •"1" ••• Barge-in is disable. •"2" ••• Barge- in is enable. 4. Push MEMORY
  • Panasonic KXT3250 | Operating Instructions - Page 18
    DETAILED OPERATION Indicators Lights • • Intercom Indicator Off Intercom is free On (green) Your extension is in use Blinking slowly (green) Intercom call on hold at your extension Blinking quickly Intercom call is (green) arriving On (red) Intercom is in use at other extension Line
  • Panasonic KXT3250 | Operating Instructions - Page 19
    Hold TO PLACE A CALL ON HOLD 1. 11 1) HOLD Push HOLD while in conversation. • In case of the outside line, the LINE Indicator light which is in conversation will start blinking slowly (green). • In case of the intercom line, the INT'COM Indicator light which is in conversation will start blinking
  • Panasonic KXT3250 | Operating Instructions - Page 20
    DETAILED OPERATION Hold (Cont.) These operation are explained using an example. In case of the intercom line, you can not have two intercom calls (one is on hold and the other is to be called). TO PLACE A CALL ON HOLD, AND MAKE OR RECEIVE ANOTHER CALL TO TALK TO FIRST CALLER WITH SECOND CALL
  • Panasonic KXT3250 | Operating Instructions - Page 21
    Intercom You can converse with another person at a parallel extension (KX-T3250B). Extension number should be assigned to each extension. MAKING AN INTERCOM intercom call is invalid. 1. Lift the handset or push the SP-PHONE button. 2. Push EXTENSION key ("1" through "5"). DETAILED OPERATION
  • Panasonic KXT3250 | Operating Instructions - Page 22
    button). 2. Push PAGE. • When the intercom use has not been programmed at your extension. 1. Lift the handset (or push the SP-PHONE button). 2. Push the INT'COM button. 3. Push the PAGE button TRANSFERRING TO ANOTHER EXTENSION Calls on outside line or intercom line may be transferred to
  • Panasonic KXT3250 | Operating Instructions - Page 23
    Paging You can page to all extensions, provided they are using DETAILED OPERATION
  • Panasonic KXT3250 | Operating Instructions - Page 24
    HOLD button. • Line 1 is on hold and a Dial-Tone is heard. 2. Push the EXTENSION-2 key. • You are now in conversation with extension-2 user. 3. Push the CONF button. 4. Replace the handset when finished. • Other parties remain connected together and continue talking with each other. 1. Push the INT
  • Panasonic KXT3250 | Operating Instructions - Page 25
    is useful to store a telephone number which is given to you by the other party during a conversation. To Dial Lift the handset (or push SP-PHONE). 1. PROGRAM Push PROGRAM during a conversation. • The MEMORY indicator will flash. 2. MEMO Push MEMO. 2. EIBEI MOD IDCIE1 OF '3 Enter the
  • Panasonic KXT3250 | Operating Instructions - Page 26
    DETAILED OPERATION Memory Transfer You may store the last dialed phone number (which is already stored in the REDIAL button) into the DIRECT CALL button. STORING THE LAST DIALED NUMBER (Redial Memory Transfer) 1. PROGRAM 2. 0 -o Cs 3. REDIAL
  • Panasonic KXT3250 | Operating Instructions - Page 27
    number without waiting for the line access or computer tone. a required when waiting for an tone. Example: 9 PAUSE --I Phone No. Line Access No. A pause is required for manual dialing, if the redial feature is used. • If the Pause button is pushed twice or more, the dialing sequence is resumed
  • Panasonic KXT3250 | Operating Instructions - Page 28
    , the Dialing Mode will TONE be automatically returned to pulse mode. COMBINATION DIALING Any combination of dialing methods can be done. •Automatic and Manual Dialing. •Pulse and Tone Dialing •Multiple Memory Stations CALL WAITING The FLASH button can be used for Call Waiting. For more details
  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
MODEL
No.
Modelo
No.
2
-LINE
INTEGRATED
TELEPHONE
SYSTEM
Sistema
de
telefono
integrado
de
2
lineas
KX-T3250B
Telephone
with
Automatic
Dialer
and
Intercom
telefono
con
marcador
autornatico
e
interfono
•
Please
read
before
use.
Le
rogamos
leer
antes
de
utilizer.
Operating
Instructions
Instrucciones
de
operacion
ci
o.
INTERCOM
Installation
Procedure
2
Connection
3
Preparation
6
Basic
Operation
Manual
outward
dialing
and
receiving
8
Switching
to
hands
-free
or
handset
10
Mute
operation
10
Automatic
dialing
11
Station
Programming
13
Detailed
Operation
Indicators
light's
17
Hold
18
Intercom
20
Paging
22
Conference
23
Storing
number
during
a
conversation
24
Memory
transfer
25
Pause
usage
26
Other
features
27
Information
Tarjeta
de
referencia
rapida
28
Procedimiento
de
Instalaci0n,
Conexi6n
32-35
Troubleshooting
guide,
others
36-37
Connection
to
the
Telephone
Line
38
Conexi0n
a
la
linea
de
Telefono
40
D
et
0
3
ti)
5'
z