Panasonic PT56LCZ7 Lifi Hdtv - Page 7
Getting Started, Remote Control Battery Installation, Reset All Memory Functions - power supply
View all Panasonic PT56LCZ7 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 7 highlights
Getting Started < Side view > 30º 30º At least 1.8 m (PT-50LCZ70/PT-50LCZ7/PT-50LCZ70-K) / 2.0 m (PT-56LCZ70/PT-56LCZ7/PT-56LCZ70-K) / 2.2 m (PT-61LCZ70/PT-61LCZ7/PT-61LCZ70-K). Remote Control Battery Installation Requires two AA batteries (supplied). 1. While pressing in on the catch, open cover in direction of arrow. 2. Install batteries in the battery compartment. • Battery polarity (+) and (-) must match the markings inside the compartment. Two AA size 3. Press cover until it snaps shut. CAUTION Incorrect battery installation can cause the batteries to leak, leading to personal injury and/or damage to the Remote Control. Observe the following precautions: 1. Always replace batteries with a pair of new ones. 2. Do not combine a new battery with an old one. 3. Do not mix battery types (example: "Zinc Carbon" with "Alkaline"). 4. Do not attempt to charge, short-circuit, disassemble, heat or burn used batteries. 5. Battery replacement is necessary when the Remote Control acts sporadically or stops operating the Projection Display set. Helpful Hints: (1) Frequent Remote Control users choose long-lasting Alkaline batteries as replacements. (2) Whenever batteries are removed, you may need to reset Remote Control infrared codes. We suggest making a note of the codes on page 56 prior to setting up the remote. Reset All Memory Functions Use when moving unit to a new location, or when First Time Setup needs to be done over. Press together the VOL- button on the unit and MENU button on the Remote Control for more than 3 seconds. Selfcheck Selfcheck in progress. Please refrain from any activity. Do not turn off or unplug the TV. After the above message indication disappeared, unplug the unit then plug it back in and turn power ON. Note • When using "EZ Sync™ "HDAVI Control™"", with the device connected, set "EZ Sync" first to "Off" and then "On" using the Setup Menu. (p. 52-53) 7