Panasonic PVGS70D PVGS70D User Guide - Page 98
White Balance Adjustment, Time Code, Memory Stop Function, rotate the [OFF/ON/MODE] Switch
View all Panasonic PVGS70D manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 98 highlights
ª White Balance Adjustment Depending on the type of light source, the colors recorded by the Palmcorder may be affected. In some cases, images may be recorded with a bluish or reddish hue. To minimize the effect of light on the subject's color, White Balance Adjustment becomes necessary. White Balance Adjustment White Balance Adjustment recognizes the color of light and makes adjustment so that the white color will become pure white. Auto White Balance Adjustment This Palmcorder stores settings that are optimal for several kinds of general light sources. The Palmcorder determines the hue of light that it receives through the lens and White Balance Sensor, thereby judging the recording condition, and selects the closest hue setting. This function is called Auto White Balance Adjustment. However, since white balance settings for only certain kinds of light sources are stored, the Auto White Balance function does not operate properly when recording occurs under light that is out of the range of the setting values. ª Time Code Time Code signals are data that indicate time measured in hours, minutes, seconds, and frames (30 frames per second.) If this data is included in a recording, an address is assigned to each image on the tape. ≥The Time Code is automatically recorded as a part of the sub-code at each recording. ≥When a new (previously unrecorded) Cassette is inserted, the Time Code automatically starts from zero. If a recorded Cassette is inserted, the Time Code picks up from the point where the last scene was recorded. (In this case, when the Cassette is inserted, the zero display [0h00m00s00f] may appear, but the Time Code starts from the previous value.) ≥The Time Code cannot be reset to zero. ≥Unless the Time Code is continuously recorded from the beginning of a tape, accurate editing may not be possible. To ensure that the Time Code will be recorded with no breaks, we recommend the use of the Camera Search Function (l 28) or the Blank Search Function (l 46) before recording a new scene. ª Memory Stop Function The Memory Stop Function is useful for the following operations. Rewinding or fast-forwarding a tape to a desired position 1 Set [DISPLAY SETUP] >> [C.DISPLAY] >> [MEMORY]. 2 Reset the Tape Counter to zero at the tape position from which you want to play it back later. (l 15, 24) 3 Start playback or recording. 4 When playback or recording is over: rotate the [OFF/ON/MODE] Switch and set the Palmcorder in the VCR Mode. ≥The [VCR] Lamp lights up. 5 Rewind the tape. ≥The tape automatically stops approximately at the position where the counter was set to zero. Stopping editing automatically during audio dubbing 1 Set [DISPLAY SETUP] >> [C.DISPLAY] >> [MEMORY]. 2 Reset the Tape Counter to zero at the position where you want to stop editing. 3 Play back the still pictures where you want to start audio dubbing. 4 Start audio dubbing. (l 51) ≥Audio dubbing automatically stops at the position where the counter was set to zero. 98