Panasonic SABT100 Blu-ray Dvd Home Theater Sound System - Page 18

Enjoying the FM/AM radio [SELECTOR] [X], [W] Manual tuning 1 Press [FM/AM] to select "FM" or "AM". Main unit: Press [SELECTOR]. 2 Press [6, 5] to select the frequency. Main unit: Press [X] or [W]. ≥When a radio broadcast is being received, "TUNED" lights in the display. TUNED QT9129 18 [FM/AM] Numbered buttons [6, 5] [:, 9] [OK] [2, 1] [FM MODE] [AM BP] ≥When a stereo broadcast is being received, "ST" lights in the display. TUNED ST ≥To start automatic tuning, press and hold [6, 5] until the frequency starts scrolling. Tuning stops when a station is found. Presetting stations manually Up to 30 stations can be set in each band, FM and AM. 1 Press [FM/AM] to select "FM" or "AM". 2 Press [6, 5] to select the frequency. 3 Press [OK]. "P" and "M" begin to flash. M 4 Press the numbered buttons to enter preset channel number. ≥To select a 1-digit number e.g., "1": [1] > [OK]. ≥To select a 2-digit number e.g., "12": [1] > [2]. e.g., "12" ≥A station previously stored is overwritten when another station is stored in the same channel preset. ≥Repeat steps 2 to 4 to set other stations. Selecting the preset channels 1 Press [FM/AM] to select "FM" or "AM". 2 Press the numbered buttons to select the channel. ≥To select a 1-digit number e.g., "1": [1] > [OK]. ≥To select a 2-digit number e.g., "12": [1] > [2]. e.g., "12" Alternatively, press [:, 9] or [2, 1] to select the channel. NOTE If noise is excessive When "FM" is selected Press [FM MODE] to display "MONO". TUNED MONO ≥Press the button again to cancel the mode. ≥The mode is also canceled when you change the frequency. ≥This setting can be preset for each broadcasting station. When "MONO" appears follow procedures 3 and 4 in "Presetting stations manually" (> above). When "AM" is selected Press [AM BP] to select "AM BP1" or "AM BP2" that receives good reception. Each time you press the button: AM BP1(.AM BP2 (BP=Beat Proof) e.g., "AM BP1" is selected. TUNED FM frequency step Main unit only The step is factory-set to 0.2-MHz (200-kHz), but you can change it to receive broadcasts allocated in 0.1-MHz (100-kHz) steps. 1 Press [SELECTOR] to select "FM". 2 Press and hold [SELECTOR]. After a few seconds the display changes to show the current minimum frequency. Continue to hold the button down. The minimum frequency changes and the step is changed. To return to the original step, repeat steps 1 and 2. After changing the setting, previously preset frequencies will be cleared. Preset them again.