Panasonic SAHT730 Dvd Theater Receiver - Page 37

Troubleshooting guide Menus The Setup menu cannot be accessed. ≥Select "DVD/CD" as the source. ≥Cancel program and random play. Page - 20 Picture abnormal or unviewable Picture distorted. ≥Ensure that the unit is connected directly to the television, and is not connected through a video 11 cassette recorder. Picture size doesn't fit the screen. ≥Change "TV Aspect" in the "Video" tab. 26 ≥Use the television to change the aspect. If your television does not have that function, change 25 "4:3 Aspect" in Display Menu. ≥Change the Zoom setting. 19 Menu is not displayed correctly. ≥Restore the zoom ratio to "a1.00". 19 ≥Set "Subtitle Position" in Display Menu to "0". 25 ≥Set "4:3 Aspect" in Display Menu to "Normal". 25 Auto zoom function does not work well. ≥Turn off TV's zoom function. - ≥Use the other preset aspect ratios or manual adjustment. 19 ≥Zoom function may not work well, especially in dark scenes and may not work depending on the - type of disc. The picture on the television ≥Mobile telephone chargers can cause some disturbance. - disappears or stripes appear on ≥If you are using a TV indoor antenna, change to an outdoor antenna. - the screen. ≥The television antenna wire is too close to the unit. Separate the antenna wire of the television - from the unit. Progressive video There is ghosting when progressive output is on. ≥This problem is caused by the editing method or material used on DVD-Video, but should be 25 corrected if you use interlace output. Change "Video Output Mode" in Picture Menu to "480i". Pictures not in progressive output. ≥Press [PROGRESSIVE] on the main unit so "PRG" is displayed. Or select "480p" in "Video 16, Output Mode" in Picture Menu. 25 ≥If the unit is connected to the television through VIDEO OUT or S-VIDEO OUT terminal, output 11 will be interlace even if "PRG" is displayed. Closed captions not displayed. ≥When progressive output is on, closed captions will not be displayed. - Listening to the radio Noise is heard. ≥Adjust the position of the FM or AM antenna. - "ST" flickers or doesn't light. ≥Use an outdoor antenna. 29 Sound is distorted. A beat sound is heard. ≥Turn the television off or move it away from the unit. - A low hum is heard during AM ≥Separate the antenna from other cables. - broadcasts. Television operation Cannot operate the TV. ≥Press [TV] first to operate the television. - ≥Check the remote control code for the TV manufacturer. 33 Unit displays The display is dark. "NOPLAY" "NODISC" "F61" "DVD U11" "ERROR" "DVD H stands for a number. "[W]" is flashing. (When using optional SH-FX50) "W01" is flashing or lit. (When using optional SH-FX50) ≥Select "Bright" in "FL Dimmer" in the "Others" tab. ≥You inserted a disc the unit cannot play; insert one it can. ≥You inserted a blank disc. ≥You haven't inserted a disc; insert one. ≥You haven't inserted the disc correctly; insert it correctly. ≥Check and correct the speaker cord connections. If this does not fix the problem, there is a power supply problem. Consult the dealer. ≥Disc is dirty. Wipe it clean. ≥Incorrect operation performed. Read the instructions and try again. ≥Trouble may have occurred. The number following "H" depends on the status of the unit. Turn the unit off and then back to ON. Alternatively, turn the unit off, disconnect the AC power supply cord, and then reconnect it. ≥If the service numbers fail to clear, note the service number and contact a qualified service person. ≥There is no link between the main unit and the receiver. Check that the receiver is turned on. ≥Ensure that the digital transmitter is fully inserted into the slot of the main unit. ≥Re-initialize the main unit: While stopped and "DVD/CD" is the source, press and hold [∫] on the main unit and [S10] on the remote control until "Initialized" disappears from the television. Turn the unit off and on again. If the problem persists, contact a qualified service person. 27 15 - - 16 4, 5, 7, 10 15 - - - - - - Television displays "/" "Cannot display group xx, content xx" "This disc may not be played in your region" No on-screen display. ≥The operation is prohibited by the unit or disc. ≥You are trying to display incompatible contents. ≥You can only play DVD-Video if their region number is the same or includes the same region number as the unit or if the DVD-Video is marked "ALL". Confirm the region number for the unit on the rear panel. ≥Select "On" in "On-Screen Messages" in the "Display" tab. - - Cover page 27 RQT7972 37