Panasonic SAHT822V SAHT822V User Guide - Page 44
RADIO & OTHERS, THE RADIO, Press [FM/AM] to select FM or AM.
View all Panasonic SAHT822V manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 44 highlights
The radio Press [TUNER] to put the remote control in TUNER mode. Numbered buttons TV INPUT SELECTOR DVD/VHS FM/AM DVD VHS TV TUNER DISC 1 1 DISC 2 2 DISC 3 3 DISC 4 DISC 5 CH 456 PICTURE MODE 78 VOLUME 9 SETUP ENTER 100 0 S10 SKIP SLOW/SEARCH OPEN/CLOSE/EJECT JET REW CD MODE FM/AM TUNER CH CH ENTER TOP MENU NAVI DIRECT NAVIGATOR OSD/ DISPLAY ENTER MENU PLAY LIST RETURN POWER Í/I INPUT SELECTOR 1 2 3 4 5 DISC DISC 5 4 3 2 1 DISC CHANGE OPEN/CLOSE DISC CHECK STOP PLAY -DEMO /REW FF/ STOP PLAY PHONES DOWN EJECT VOLUME CH REC UP TV VOL RESET TV/VIDEO PAGE GROUP TV VOL MIX 2CH REPEAT SUBTITLE PLAY MODE MULTI RE-MASTER C.S.M C.FOCUS PROGRESSIVE SUBWOOFER LEVEL SFC SUPER SRND MUTING Automatic presetting PLAY MODE INPUT SELECTOR Selecting the preset channels Up to 15 stations can each be set in the FM and AM bands. 1 Press [FM/AM] to select "FM". 2 Press [6] or [5] to tune to the lowest frequency ("FM 87.9" MHz or "FM 87.5" MHz). 3 Press and hold [ENTER]. Release the button when "AUTO" is displayed. The tuner presets all the stations it can receive into the channels in ascending order. ≥"SET OK" is displayed when the stations are set. The last station to be set is then played. 4 Repeat steps 1 to 3 to set the AM bands (the lowest frequency is "AM 520" kHz). Manual tuning 1 Press [FM/AM] to select "FM" or "AM". 2 Press [6] or [5] to select the frequency. Press and hold [6] or [5] until the frequency starts scrolling to start automatic tuning. Tuning stops when a station is found. Presetting the channel one by one 1 Tune to the station (➜ above). 2 Press [ENTER]. 3 While "PGM" is flashing on the display Press the numbered buttons to select a channel. Alternatively, press [W CH] or [X CH] then press [ENTER]. 1 Press [FM/AM] to select "FM" or "AM". 2 Press the numbered buttons to select the channel. Alternatively, press [W CH] or [X CH]. To select a 2-digit number e.g. 12: [S10] ➜ [1] ➜ [2]. When a stereo FM broadcast is being received. ST TUNED ∫ If noise is excessive in FM Press [PLAY MODE] to display "MONO". MONO Press [PLAY MODE] again to cancel the mode. The mode is also canceled when you change the frequency. ∫ FM frequency step Main unit only The step is factory-set to 0.2 MHz, but you can change it to receive broadcasts allocated in 0.1-MHz steps. 1 Press [INPUT SELECTOR] on the main unit to select "FM". 2 Press and hold [INPUT SELECTOR]. After a few seconds the display changes to show the current minimum frequency. Continue to hold the button down. The minimum frequency changes and the step is changed. To return to the original step, repeat the above steps. [Note] Any FM/AM frequencies preset in channels will be changed by this procedure. Preset them again. PGM RQT7708 The station occupying a channel is erased if another station is preset 44 to that channel.