Panasonic SAHT930 Dvd Theater Receiver - Page 29

The radio ∫ FM frequency step Main unit only You can change the FM step. The step is factory-set to 0.2 MHz, but you can change it to receive broadcasts allocated in 0.1-MHz steps. 1 Press [INPUT SELECTOR] to select "FM". 2 Press and hold [INPUT SELECTOR]. After a few seconds the display changes to show the current minimum frequency. Continue to hold the button down. The minimum frequency changes and the step is changed. To return to the original step, repeat the above steps. [Note] After changing the setting, previously preset frequency will be cleared. Preset it again. Optional antenna connections Use outdoor antennas if radio reception is poor. ≥Disconnect the antenna when the unit is not in use. ≥Do not use the outdoor antenna during an electrical storm. FM outdoor antenna (Using a television antenna) ≥Disconnect the FM indoor antenna. ≥The antenna should be installed by a competent technician. Rework your outdoor antenna's 75 ≠ coaxial cable as follows. 75 ≠ coaxial cable (not included) \U.S.A.\and\Canada] Antenna plug (not included) DIGITAL TRANSMITTER A The illustration shows SC-HT730 for U.S.A. and Canada. Leave the AM loop antenna connected. AM outdoor antenna (Using a vinyl wire) Run a piece of vinyl wire horizontally across a window or other convenient location. FM ANT (75≠) AM ANT L LOOP EXT R 5-12 m (16 - 39 feet) 1 Remove a piece of the outer vinyl insulator. 10 mm (13/32z) 10 mm (13/32z) Peel back 2 Carefully pull the tabs apart to remove the cover. 2 1 1 7 mm (9/32z) 3 Install the coaxial cable. Clamp the cable conductor, and wind it on so that it does not contact anything else. 4 Attach the cover. Clamp with pliers RQT7972 29