Panasonic SC-HC27 Operating Instructions

3

Connect the AC mains lead.

Power consumption in standby mode:

approximately 0.2 W.

Note:

•

Some settings return to default when you

disconnect the system.

•

These speakers do not have magnetic shielding.

Do not put them near TVs, PCs or other equipment

easily influenced by magnetism.

•

You cannot remove the net of the speakers.

Operating Instructions

Compact Stereo System

Model No.

SC-HC27

GN

Panasonic Corporation

Web Site: http://panasonic.net

© Panasonic Corporation 2011

RQT9577-L

L1211HH0

En

Dear Customer

Thank you for purchasing this system.

For optimum performance and safety, read these instructions

fully before you connect, operate or adjust this system.

Keep this manual for future reference.

Your system and the illustrations can look differently.

Do the procedures with the remote control. You can also

use the buttons on the main unit if they are the same.

Safety precaution

Bottom of product

Inside of product

Product Identification Marking is located on the

bottom of the unit.

WARNING

Unit

•

To reduce the risk of fire, electric shock or product

damage,

– Do not expose this unit to rain, moisture, dripping

or splashing.

– Do not place objects filled with liquids, such as

vases, on this unit.

– Use only the recommended accessories.

– Do not remove covers.

– Do not repair this unit by yourself. Refer servicing

to qualified service personnel.

– Do not let metal objects fall inside the system.

– Do not handle the plug with wet hands.

Batteries

•

Risk of fire, explosion and burns. Do not recharge,

disassemble, heat above 60°C or incinerate.

•

Keep the Button-Type battery out of the reach of

children. Never put Button-Type battery in mouth. If

swallowed call your doctor.

CAUTION

Unit

•

To reduce the risk of fire, electric shock or product

damage,

– Do not install or place this unit in a bookcase,

built-in cabinet or in another confined space.

Ensure this unit is well ventilated.

– Do not obstruct this unit’s ventilation openings

with newspapers, tablecloths, curtains, and

similar items.

– Do not place sources of naked flames, such as

lighted candles, on this unit.

– Set the system up on an even surface away from

direct sunlight, high temperatures, high humidity,

and excessive vibration.

– Do not use a DC power source.

– Do not use an AC mains lead from other

equipment.

•

This unit is intended for use in moderate climates.

•

Install this unit so that the AC mains lead can be

unplugged from the socket outlet immediately if

any problem occurs.

•

This unit may receive radio interference caused by

mobile telephones during use. If such interference

occurs, please increase separation between this

unit and the mobile telephone.

•

This unit utilizes a laser. Use of controls or

adjustments or performance of procedures

other than those specified herein may result in

hazardous radiation exposure.

Batteries

•

Danger of explosion if battery is incorrectly

replaced. Replace only with the type recommended

by the manufacturer.

•

When disposing the batteries, please contact your

local authorities or dealer and ask for the correct

method of disposal.

•

Do not heat or expose to flame.

•

Do not leave the battery(ies) in a car exposed to

direct sunlight for a long period of time with doors

and windows closed.

Information on Disposal in other Countries

outside the European Union

This symbol is only valid in the

European Union.

If you wish to discard this product,

please contact your local authorities or

dealer and ask for the correct method

of disposal.

Supplied accessories

Check and identify the supplied accessories.

1 x AC mains lead

1 x FM indoor antenna

1 x Remote control

(N2QAYC000059)

1 x Lithium Button-Type battery

(Battery is already installed in the remote control.)

Overview of controls

A

Standby/on switch [

`

], [

1

]

•

Press to switch the unit from on to standby

mode or vice versa. In standby mode, the unit

is still consuming a small amount of power.

B

Select audio source

C

Basic playback control

D

View the setup menu

E

View the iPod/iPhone menu

View content information

F

Select the sound effects

G

Select an item

Skip album

H

Set the sleep timer

MUTE

SETUP

DISPLAY

SOUND

ALBUM

PLAYMENU

iPod MENU

SLEEP

iPod

RADIO/

USB

CD

DIMMER

OK

I

Decrease the brightness of the display panel

•

Press and hold the button to use this function.

•

To cancel, press and hold the button again.

J

Adjust the volume of the system

K

Mute the sound of the system

•

Press the button again to cancel.

•

“MUTE” is also cancelled when you adjust the

volume or when you switch off the system.

L

View the play menu

M

USB port (

)

N

Headphones jack (

)

•

Plug type: Ø 3.5 mm stereo (not supplied)

•

Avoid listening for prolonged periods of time to

prevent hearing damage.

•

Excessive sound pressure from earphones and

headphones can cause hearing loss.

•

Listening at full volume for long periods may

damage the user’s ears.

•

Be sure to use the supplied or recommended

headphones or earphones.

O

Open or close the sliding door

P

Remote control sensor

•

Maximum range: 7m directly in front

Q

Sliding door

R

Display panel

S

Open or close the iPod/iPhone dock

1

Connect the FM indoor antenna.

Place the antenna where reception is best.

2

Connect the AM loop antenna

Adhesive

tape

To household mains socket

CR2025

Insulation sheet

A

B

O

J

C

N

M

S

R

Q

P

Top view

Front view

Getting started

“Made for iPod” and “Made for iPhone” mean

that an electronic accessory has been designed

to connect specifically to iPod, or iPhone,

respectively, and has been certified by the

developer to meet Apple performance standards.

Apple is not responsible for the operation of this

device or its compliance with safety and regulatory

standards.

Please note that the use of this accessory with

iPod, or iPhone may affect wireless performance.

iPhone, iPod, iPod classic, iPod nano, and iPod

touch are trademarks of Apple Inc., registered in

the U.S. and other countries.

MPEG Layer-3 audio coding technology licensed

from Fraunhofer IIS and Thomson.

Amplifier section

RMS output power stereo mode

Front Ch (both ch driven)

5 W per channel (6

), 1 kHz, 10% THD

Total RMS stereo mode power

10 W

Tuner, terminals section

Preset station

FM 30 stations

Frequency modulation (FM)

Frequency range

87.50 MHz to 108.00 MHz (50 kHz step)

Antenna terminals

75

(unbalanced)

Frequency modulation (AM)

Frequency range

522 kHz to 1629 kHz (9 kHz step)

520 kHz to 1630 kHz (10 kHz step)

Headphones jack

Terminal

Stereo, 3.5 mm jack

Disc section

Disc played (8 cm or 12 cm)

CD, CD-R/RW (CD-DA, MP3

formatted disc)

MPEG-1 Layer 3, MPEG-2 Layer 3

Pick up

Wavelength

790 nm (CD)

Laser power

CLASS

I

(CD)

Audio output (Disc)

Number of channels

2 ch (FL, FR)

FL = Front left channel

FR = Front right channel

USB section

USB port

USB standard

USB 2.0 full speed

Media file format support

MP3 (

.mp3)

USB device file system

FAT 12, FAT 16, FAT 32

USB port power

500 mA (max)

Speaker section

Type

1 way, 1 speaker system (bass reflex)

Speaker unit(s)

Full range

8 cm cone type

Impedance

6

General

Power supply

AC 220 to 240 V, 50 Hz

Power consumption

19 W

Power consumption in standby mode

0.2 W (approximate)

Dimensions (W x H x D)

400 mm x 213 mm x 110 mm

[D = 72 mm (min)]

[D = 144 mm (tray open)]

Mass

2 k

g

Operating temperature range

0°C to +40°C

Operating humidity range

35% to 80% RH (no condensation)

Note:

•

Specifications are subject to change without notice.

Mass and dimensions are approximate.

•

Total harmonic distortion is measured by the digital

spectrum analyzer.

Specifications

Maintenance

To clean this system, wipe with a soft, dry cloth.

•

Never use alcohol, paint thinner or benzine to clean

this system.

•

Before using chemically treated cloth, read the

instructions that came with the cloth carefully.

Preparing the remote control

Before using

Replacing the battery

Replace with a new battery only (CR2025).

1

While pressing the stopper, pull out the

battery holder.

2

Insert a new battery with the (+) side facing

up.

3

Push the battery holder back fully.

D

DRAFT

Panasonic SC-HC27 Operating Instructions

Panasonic SC-HC27 Manual

Panasonic SC-HC27 manual content summary: