Pfaff creative 2140 Owner's Manual - Page 46
nnnninrn
View all Pfaff creative 2140 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 46 highlights
2. Machine Assistant 2-14 Hoop embroidery For hoop embroidery, set up your possible to select a creative Card Pfaff creative 2140 properly and attach if the embroidery unit is not attached. the embroidery unit as described below. It is not Before hoop embroidering you must lower the feed dog, disengage the dual feed (IDT System), remove the knee lift and fit the embroidery foot (see below). Lowering the feed dog The feed dog must be lowered for hoop embroidery. To lower the feed dog move the slide (4) to the left. Note: Raise the presser foot before lowering the feed dog The thread tension is automatically set and can be adjusted for speciality techniques. -Th / i'i' nnnninnnnnnrn Disengaging the top feed/dual feed The top feed must be disengaged for embroidery work. Procedure: Hold the dual feed firmly at the ribbing with two fingers. Press the top and release it feed (red) fully slowly upward downwards, then pull it away from until it engages in normal position. you Removing the knee lifter The knee lifter is not needed for embroidery work and must be removed. To remove the knee lifter, just pull it out of the hole. Attaching the embroidery foot 1. Remove the standard presser foot. Carefully loosen the screw (S) until the cross-hole (T) is accessible. 2. Squeeze the embroidery foot of the foot into the cross hole gently together and guide of the presser foot holder the pin as far as it will go. 3. Tighten the screw (5). To remove the embroidery foot loosen the screw the embroidery foot together and pull it out to the (S), squeeze right. Tighten 1. the screw (S). 2. 3.