Pfaff hobbylock 776 Owner's Manual

Pfaff hobbylock 776 Manual

Get Pfaff hobbylock 776 PDF manuals and user guides View all Pfaff hobbylock 776 manuals
Add to My Manuals
Save this manual to your list of manuals

Pfaff hobbylock 776 manual content summary:

  • Pfaff hobbylock 776 | Owner's Manual - Page 1
    fh©EbEbyfl©©D 71 OPERATING INSTRUCTiON
  • Pfaff hobbylock 776 | Owner's Manual - Page 2
    how to adjust 11 12 g. Roll hemming h. Points to observe during sewing 13 14 i. 3-thread overedge seam 15 D. Some adjustment / Maintenance 15 a. Adjusting the seam width 16 b. Adjusting the stitch length 16 c. Differential feed mechanism 17 d. Replacing needle (S) 18 e, Replacing the
  • Pfaff hobbylock 776 | Owner's Manual - Page 3
    A. Parts name o Front side Telescopic thread reel stand bar • Rear side Pulley wheel feet 2
  • Pfaff hobbylock 776 | Owner's Manual - Page 4
    speed Overlock seam width Stitch length Presser foot Presser foot lift Needle Number of threads Lubrication Dimentions Net weight 1 300 s.p.m. 3.5mm (standard) 1.0 - 4.0mm Hinged 5mm 130 / 705H No.75 - No.90 4 Manual 278(W) x 264(D) x 310(H) 7Kg Brush for dusting Roll hemming presser foot Upper
  • Pfaff hobbylock 776 | Owner's Manual - Page 5
    for the sewing a. Preparation This machine must be used on a flat and horizontal surface or purpose-built sewing machine table. b. Fitting the foot controller cFinoirnsthtn,eeicnitsloleurrsttsrtoahcteikoecnot, notthnroetnlhleecr omcnoanncenhceitncettohaersipnslthuoogwthtneo a power source. c. How
  • Pfaff hobbylock 776 | Owner's Manual - Page 6
    e. Lubrication The bushings and other important parts are made from special materials and only require lubrication once or twice a month. When oiling always be sure to use a good quality sewing machine oil. Apply just one or two drops of oil to the areas indicated. 5
  • Pfaff hobbylock 776 | Owner's Manual - Page 7
    you. 3. To close the looper cover, push the looper cover upwards lightly towards the machine until it clicks and it will close securely. g. Threading procedure 1. Ensure that the telescopic thread guide bar is at maximum vertical height. 2. Threading must be done carefully in accord ance with the
  • Pfaff hobbylock 776 | Owner's Manual - Page 8
    C0 D . '< r °Cl) 0C (Do - CD 0) ci 1) cr 0 C 01 0 0) 0 0 C r'j -1 cY. O(D ocn cc -1 -, C 1 CD CD - a, (DD 0. CD D) ci Q) 0 CD 0 C CD (3I C) 0 CD 0) 0 C 0 0 r\) CD -' -% Cl, 0 0 z a. z. e a. I 0 -I C V V 0 0 0 •0 CD
  • Pfaff hobbylock 776 | Owner's Manual - Page 9
    3. Next thread the right needle 4. Lastly thread the left needle surplus thread needle eyes. about 5 cm (about 2') surplus thread beyond needle eyes. about 5 cm (about 2') tO(chI4torn)w,elcoateohuduirssyledodtwhuibaltlhetariradeehreaeendsltpatsiotffiuyaslbfrtieeheineduuststthehehdedrae
  • Pfaff hobbylock 776 | Owner's Manual - Page 10
    slowly towards you with your right hand. Checking the threads being interlocked. 2. Insert the cloth under the presser foot up to the edge of the upper cutter and start sewing slowly. b. Thread tension adjustment (Normal hemming) The correct thread tension varies depending on the fabric and type and
  • Pfaff hobbylock 776 | Owner's Manual - Page 11
    chart for fabrics and thread stitch length Normal hemming Roll hemming Fabrics Light Organdy, light-knit fabric, Taffeta, silk,lining materials Medium Cotton, tricot, linen, dress materials Heavy Tweed, suit materials, denim, heavy cloth Knit fedrics georgette tricot Thread Cotton Silk No.80
  • Pfaff hobbylock 776 | Owner's Manual - Page 12
    f. Incorrect thread tension and how to adjust 1. The sketch shows the left needle thread tension is too loose. 2. The sketch shows the right needle thread tension is too loose. 3. The sketch shows the right looper thread tension is too loose. 4. The sketch shows the left looper thread tension is too
  • Pfaff hobbylock 776 | Owner's Manual - Page 13
    g. Roll hemming . Roll hemming foot . Normal hemming toot • How to replace the presser toot Remove the left needle first. For the roll hemm ng (narrow / foldover hemming) replace the normal stitch foot by the roll hemming foot. By following this instruction, very good sewing results can be
  • Pfaff hobbylock 776 | Owner's Manual - Page 14
    the seam, end of sew approximately 5 the seam then cut the thread chain. • Securing the seam: Tie the thread chain. For crochet needle can be used to knit pull fabric, a the thread • cTpflhroipoaixnpfiamrbeinarvttieoecnlyttohve5uenrscreamaavnmedl.bliesnyegownodof vtsehereatmhseesa, msse
  • Pfaff hobbylock 776 | Owner's Manual - Page 15
    . 3. Seam width can be changed from 5 mm to 7 mm. (Standard seam width is 5,5 mm). • For narrow seam sewing. 1. Remove the left hand needle. 2. Use the right hand needle thread and right & left looper thread. 3. Seam width can be changed from 3 mm to 5 mm.(Standard seam width is 3.5 mm). Wide seam
  • Pfaff hobbylock 776 | Owner's Manual - Page 16
    be 5.0mm when using t1h.eOtrtrhTdihepgeioelhfeeftnkauersarnpateiiohpnnsnebedget r, Adjust the required seam width by turning the dial. \\Upper knife control knob Wide seam wtdt Narrow seam width • Anfetceerssaadrjyusttoinrgesetht ethseetahmreawdidtethn,sioitnm. ay
  • Pfaff hobbylock 776 | Owner's Manual - Page 17
    control dial (see right) NOTE: Standard stitch length is 3mm. 3. After this adjustment, close side cover C. Differential feed mechanism The differential neccssary to experiment with various ratios, using spare pieces of the same fabric and thread you intend using, until a satisfactory result is ob
  • Pfaff hobbylock 776 | Owner's Manual - Page 18
    No.75 to No.90 may be used. Light weight materials needing a finer needle, with a thicker needle for heavier weights. Fitting the left needle screw Ensure you carry out this procedure correctly as to not do so could result in thread or needle breakage and also skipped stitches. ATTENTION When
  • Pfaff hobbylock 776 | Owner's Manual - Page 19
    (in the opposite manner as abnve), and, using a screwdriver, retighten the retaining screw (A) securely knife and behind the guard on the presser foot. It is now ready for normal operation. in this position, re-tighten the screw (A) securely, using a screw driver. If it is necessary to adjust,
  • Pfaff hobbylock 776 | Owner's Manual - Page 20
    MAINS PLUG FROM THE POWER SOURCE • Loosen the screw of the rear of the machine body and remove the lamp cover. • Turn the bulb in Insert the new direction bulb by (1) and remove it. pushing upward, turning it in the direction (2). Replace cover. Caution: Use a maximum 1 5 watt bulb only
  • Pfaff hobbylock 776 | Owner's Manual - Page 21
    Insert new needle. Insert needle correctly. Use needle system 1 30 / 705H only. Thread correctly. Incorrect setting of thread tensions Set thread tensions correctly. Thread tension too tight Thread has caught due to incorrect threading Reduce thread tension Thread correctly Sewing foot is not
  • Pfaff hobbylock 776 | Owner's Manual - Page 22
  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
fh©EbEbyfl©©D
71
OPERATING
INSTRUCTiON