Pfaff hobbylock 783 Owner's Manual

Pfaff hobbylock 783 Manual

Get Pfaff hobbylock 783 PDF manuals and user guides View all Pfaff hobbylock 783 manuals
Add to My Manuals
Save this manual to your list of manuals

Pfaff hobbylock 783 manual content summary:

  • Pfaff hobbylock 783 | Owner's Manual - Page 1
    4 I D Cl) -' © C C-) 0 D SD © D Cc)
  • Pfaff hobbylock 783 | Owner's Manual - Page 2
    safety A) Owing to the up and down movement of the needle and the upper knife, the user must take sufficient care to avoid injury and observe the sewing area continuously while sewing. B) When leaving the machine, changing parts or accessories, the machine must be disconnected from the power source
  • Pfaff hobbylock 783 | Owner's Manual - Page 3
    guide wires and the thread guides behind the carrying handle . . . 7 Threading the right looper Threading the left looper Threading the needle . . V Cleaning the thread tensions Oiling the machine Sewing problems and their removal . . Accessories Thread spool net/thread unreeling
  • Pfaff hobbylock 783 | Owner's Manual - Page 4
  • Pfaff hobbylock 783 | Owner's Manual - Page 5
    cover with recess 11 Upper knife 12 Work support (swiveLtype) 13 Needle plate 14 Sewing foot 15 Needle bar 16 Sewing foot lifting lever 17 Thread spool holder 18 Thread guides 19 Thread guide bar 20 Machine socket 21 Master switch 22 Rear thread guide (4 x) 23 Feet 24 Accessory box 25 Stitch length
  • Pfaff hobbylock 783 | Owner's Manual - Page 6
    Electrical connection Use this machine only on a fiat surface or on a special sewing table. Connecting the foot control: Insert the plug of the control in the machine socket Then connect the mains plug to a power source. Caution: When the machine is not in use, switch it off at the master switch and
  • Pfaff hobbylock 783 | Owner's Manual - Page 7
    Notes on safety A) Owing to the up and down movement of the needle and the upper knife, the user must take sufficient care to avoid injury sewing area continuously while sewing. B) When leaving the machine, changing parts or accessories, the machine must be disconnected from the power source.
  • Pfaff hobbylock 783 | Owner's Manual - Page 8
    . Tighten clamp screw A securely Insert four thread spool holders 17 with centering pieces 36 fully in the holes of the thread spool stand. Push thread guiding part 18 into guide bar 19. Pull up guide bar and align it so that thread guides 18 are exactly above the spool holders. 6
  • Pfaff hobbylock 783 | Owner's Manual - Page 9
    push it up until it locks lo open work support 12. push it to the left To close the work support, push it to the right until it locks. looper (yellow) 3. needle (blue) Figure H shows the threading path of the individual threads for thread guides 18 For threading the guides behind carrying handle 2.
  • Pfaff hobbylock 783 | Owner's Manual - Page 10
    Threading the right looper: thread the rtt looper in sequence 1 to Band tiull opproximately 10 cm (4) of thread through the looper eye (the thread path s murked red) Important In order to obtdln perfect sewing results the thread must be pulled between the tension disco when threading the te nsmns 8
  • Pfaff hobbylock 783 | Owner's Manual - Page 11
    Threading the left looper: Insert the left looper thread in sequence 1 1 to 9 and pull approximately 10 cm (4 of thread through the looper eye (the thread path is marked yellow) I 9
  • Pfaff hobbylock 783 | Owner's Manual - Page 12
    needle (6). At point 5 the thread must be pulled behind the thread retainer After threading the machine, push handle 2 down, and close work support cm past the last thread guide before the needles. Cut the knots off and pull the threads through the respective needle eyes. The looper threads can
  • Pfaff hobbylock 783 | Owner's Manual - Page 13
    push the bottom of the box against the machine For removal of the lint box, use the reverse order / / Seam allowance If the cutting is guided along below marking N on the looper cover, a seam allowance of 16 mm must be taken into consideration when cutting the fabric. 11
  • Pfaff hobbylock 783 | Owner's Manual - Page 14
    Sewing test After threading a sewing test test should he made Raise sewing foot lever 16, as shown in the illustration 5thN Insert test fabric up to the upper knife and lower the sewing foot. Hold thread ends with your left hand while turning hand wheel with your right hand in the direction
  • Pfaff hobbylock 783 | Owner's Manual - Page 15
    has been rethreaded) Sew the first stitches slowly Since the fdbric is fed automatically, do not pull or push the fabric Use your hand for guiding only Sew approxirriately 5 cm beyond the end of the seam and use a scissors to cut the thread chain. 13
  • Pfaff hobbylock 783 | Owner's Manual - Page 16
    Securing the seam: Knot the thread chdin For knit fabrics, a crochet needle can be ued to pull the thread chain into the eani Or: Sew about 5 cm (2 beyoi d the end of scam Then turn the work piece
  • Pfaff hobbylock 783 | Owner's Manual - Page 17
    Setting the standard thread tension N Heverse side The thread tension to be set depends on the fabric type and thread size used Left 0 Iou per thread / ; i/ .1 // ;;1 Right looper Page 16 lists examples for correction of the individual thread tensions Needle t/ i Top side i•' Wj\
  • Pfaff hobbylock 783 | Owner's Manual - Page 18
    Correcting the thread tensions When the thread tension is turned in (+) direction the tension is increased When turned iii ( > direction it is decreased The needle thread A is too loose (blue thread tcniori) The right looper thread C is too loose (red thread tension) or the left looper thread D too
  • Pfaff hobbylock 783 | Owner's Manual - Page 19
    thread (bulk thread) Stitch length 2.0 to 4 0 mm 20 to 40 mm 2.0 to 50 mm 2.0 to 5.0 mm 1.0 to 20mm Setting the stitch length Open work support 12. Hold hand wheel fast and set stitch-length adjustment 9 knob 25 at the stitch length desired between 1 arid 5 mm is 3 mm. Standard setting N 17
  • Pfaff hobbylock 783 | Owner's Manual - Page 20
    L \ N, 1 kf[J) Disengaging the upper knife Remove lint bn 8 Open work support 12 arid looper cover 10 If necessary, loosen screw '38 for axial upper knife hi ock ng Push rotary lenr 27 of the axial upper knife guide full,' to the rrght, hold it, and turn it forwards until pin A engages in the
  • Pfaff hobbylock 783 | Owner's Manual - Page 21
    F G Changing the sewing foot 1 Raise sewing fuot lifting ever 16 Disengage ever F the sewing foot by pressing Engage the sewing foot. sosfPeoeflwwoatthciinneehggotfhloffdeoooeotorstteeswhlnoiofgitnliatdnhgggeaertflsoewovinthereugnnrcodryoeoovrsuestphlHojeewocsefeerwtGhthieneg The
  • Pfaff hobbylock 783 | Owner's Manual - Page 22
    101) side Reverse side Rolled hem sewn with polyester thread 120--140 ssofAceapwabreorrnvWipcesreesoddafgenshehsdesasmiwiosWLriias,ainttuafnisuroedotudtlrtlveafaadconltraihyvnleiecemgefhffssitonriodtsnheylonifcouearctckedn (see page 21) lop side Reverse side
  • Pfaff hobbylock 783 | Owner's Manual - Page 23
    setting: round edge, Fig. 1 flat edge, Fig. 2 Red thread tension, right looper Yellow thread tension loft limper Blue thread tension, needle thread upprox. "N" +5 appi ox "N" approx + 5 approx "N" to - 1 upprox "N" to + 1 3epending on material and thread, the respective thread tension must be
  • Pfaff hobbylock 783 | Owner's Manual - Page 24
    H (75- 90) ( oAnlththoeugmh attheeriacloarrnedctthneeethdrleeasdizseizdeepends used, we recommend needle size 75 90 An incorrectly inserted needle will cause thread breakage and skipped s ti let res. Changing the knives Knives are avuilulile as spare parts Pull out the mains plug. Disengage the
  • Pfaff hobbylock 783 | Owner's Manual - Page 25
    1; I I c Changing the upper knife: Pull out the mains plug. Unscrew knife rerr1cje upper rctdriring knife screw 35 arid / iItnssreerttatihneingneswcruewppeSreckunriefelyand tighten 1 pu(Scnoeutstitilttuiitnophgnpeepuropkspinteiifroenk)wniifTtehuriknsnatifhteeitgshualiondwdewe2sh7teeulp
  • Pfaff hobbylock 783 | Owner's Manual - Page 26
    screw 34 of the lower k n fe Place the new lower knife against the left guide of the lower knife holder and push it up, as shown in the illustration. Replace knife so that it is flush with the needle plate surface Before tightening the retaining screw, align the pressure plate. Reset the upper
  • Pfaff hobbylock 783 | Owner's Manual - Page 27
    ) ) / I ' H / ( Changing the hght bulb: Pull out the mains plug. ousen housing cer retaining screw 4 Open the hoicei g cover Behind it, the lijhl bulb of the sewing light is situated Removing the light bulb: Push the light bulb upwards and turn it fully to the left Inserting the light bulb: Insert
  • Pfaff hobbylock 783 | Owner's Manual - Page 28
    Oiling the machine: otoraoFwririinlilivloadeoaetddrordeoyeorottpoohhtnsiefpuleemyrsfrsafepptoiioiclemnofbaicecncephineefaoiotgslrJorhtofmeiaronunqratdytwutsooieachmiiurllcaoiiioetantuteyvalgldaki.dasn.eemngaTwdptohphipnennaeltgeryhbtme.suamdaOsaaclhtrinchotietnehilnegbitneseoe 26
  • Pfaff hobbylock 783 | Owner's Manual - Page 29
    easy operation. and e made peratiori Sewing problems of ftc tind described below may errors Ihey can easily be corrected by follnwing the there etc ucr;ur (1(10 rnstruchoi tO difhcult adlustments fri 10 minOr adjust rnent and . below. Prohlerri Needle breakage Thread breakage Skipped stitches
  • Pfaff hobbylock 783 | Owner's Manual - Page 30
    60 Accessories I Screwcii vol (big) 2 Screwdriver (small) 3 nt bru h 4 Tweezer, 5 Upper kniif 6 Thread uereehng disc 7 Needles 8 Sewing rTldchine oil 9 Rolled hem sewing foot 10 Thread spool net 11 Needle change tool 11 )Y'i' (115i] Thread spool net Very useful for synthetic threads Which tend to
  • Pfaff hobbylock 783 | Owner's Manual - Page 31
    ewing speed Seam width Stitch length Sewing foot I uhricatuori . Sewing foot height Needle system Number of threads Dimensions . Weight Contents of cardboard box 1 umiachune with motor 1 foot control 1 instruction manual/gu000ltee certificate 1 lint box 1 thread spool stand 4 thread spool stand bars
  • Pfaff hobbylock 783 | Owner's Manual - Page 32
  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
4
I
D
Cl)
-‘
C
C-)
0
D
D
C
c)
©
SD
©