Philips 15PF8946 Quick start guide (English)
Philips 15PF8946 - 15" LCD TV Manual
 |
View all Philips 15PF8946 manuals
Add to My Manuals
Save this manual to your list of manuals |
Philips 15PF8946 manual content summary:
- Philips 15PF8946 | Quick start guide (English) - Page 1
Philips LCD Television set. You are now the proud owner of a LCD TV set which promises full value to you as a customer. Before you proceed to install the LCD TV flat surface. 23"/58cm 20"/51cm For the 20"/23" models, open back plate cover by gently pulling upwards. 17"/44cm 15"/39cm For the 15"/17 - Philips 15PF8946 | Quick start guide (English) - Page 2
LCD TV Quick Use and Hookup Guide CONTENTS Presentation of the LCD Televison 2 Remote Control Operation 2 Hooking Up the Television Remote Control Batteries 3 Cable/Cable Box TV 3 Antenna TV 3 AV1 Inputs 4 Component (CVI) Inputs 4 HD (High Definition Inputs 4 PC (Monotor) Inputs 4 AV2 - Philips 15PF8946 | Quick start guide (English) - Page 3
into the AV In jack on the bottom of the TV. Video Cable (Yellow) 2 NOTE: Use the Source button on the remote control to tune to the AV1 channel for the cable box signal. Once tuned, change channels at the cable box, not the television. Pressing the Source button repeatedly will scroll all the - Philips 15PF8946 | Quick start guide (English) - Page 4
) ON, press the PLAY button of the VCR to view the tape on the television. 4 Note : The Audio/Video cables needed for this connection are not supplied with your TV. Please contact your dealer or Philips at 800-531-0039 for information about purchasing the needed cables. Jack Panel at bottom - Philips 15PF8946 | Quick start guide (English) - Page 5
signal. Note : For the display resolutions available to your TV, refer to the Operating Instruction Manual Please contact your dealer or Philips at 800-531-0039 for information about purchasing the needed cables. JACK PANEL at REAR of TV JACK PANEL at REAR of TV JACK PANEL at REAR of TV 3 PC 15
-
1 -
2 -
3 -
4 -
5
 |
 |
If you intend to install the LCD TV on the wall. ensure you have the following :
– Standard
VESA 100 bracket for 15"/17"/20"/23" LCD TV (not supplied) and four spacers found in the accessory bag.
3139 125
32112
LCD TV
LCD TV
Thank you for purchasing this Philips LCD Television set. You are now the proud owner of a LCD TV set which
promises full value to you as a customer. Before you proceed to install the LCD TV, please follow the steps and
diagrams as shown to familiarise yourself with the correct and safe way of assembling the stand to the TV.
2
23"/58cm
20"/51cm
17"/44cm
15"/39cm
3
A
SSEMBLING THE
S
TAND
I
NSTALLING
LCD TV
ON THE
W
ALL
For the 20"/23" models, open back
plate cover by gently pulling upwards.
For the 15"/17" models, open back
plate cover by sliding the plate cover
downwards and then pull upwards.
Bottom of swivel base
(20"/23" models only)
Check the stand arm
is rigid and properly
installed. Place the
set upright.
VESA
Bracket
does not
fit
If your VESA bracket does not fit into the slot at
the rear of the LCD TV, proceed to make use of
the four spacers provided. Note : If VESA bracket
fits into the slot, you need not use the spacers.
1
2
3
Spacer
x 4
Screw the four spacers to the holes at the rear of
the set. Ensure the spacers are properly tightened
(torque of 1.2N-m or 1 lbf-in).
Tighten
VESA
bracket
to spacers
23"/58cm
20"/51cm
17"/44cm
15"/39cm
For the 20"/23"models,
close back plate cover
by gently pushing
downwards.
For the 15"/17" models,
close back plate cover by
sliding plate upward.
Align arrow
to the center
1
For swivelling of the stand to function properly, adjust the swivel base at
the back of the stand until arrow is aligned in the center. Align the stand
studs into the holes at the bottom of the set. Put in the screws (provided)
into the 2 holes and tightened with a screwdriver.
CAUTION : While putting in the screws, hold onto the stand.
Place the set facing down on a protective
sheet close to the edge of a flat surface.
Ensure you have the following before
you assemble the stand :
–
Two screws
(supplied with set)
–
One Screwdriver
(not supplied)
4
NOTE
: No swivel
base for 15"/17" models
Do the following when installing the LCD TV on the wall :
2
1
Ñ
Ñ
Ñ
!
Place the VESA bracket on the spacers and
tightened with the VESA bracket screws.