Pioneer AVH-P3200BT Owner's Manual - Page 77
Understanding auto EQ, error messages, Additional Information - firmware update
UPC - 012562975719
View all Pioneer AVH-P3200BT manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 77 highlights
Additional Information Appendix Additional Information iPod Message Cause Action Format Read/ Ready Sometimes there Wait until the mes- is a delay be- sage disappears tween the start of and you hear playback and sound. when you start to hear any sound. Error-02-6X/9X/-DX Communication failed. Disconnect the cable from the iPod. Once the iPod's main menu is displayed, reconnect the iPod and reset it. iPod failure Disconnect the cable from the iPod. Once the iPod's main menu is displayed, reconnect the iPod and reset it. Error-02-67 The iPod firm- Update the iPod ware versions are version. old. Stop There are no songs. Transfer songs to the iPod. There are no Select a list that songs in the cur- contains songs. rent list. iTunes tagging Message Cause Action iPod full. Tags not transferred. Memory used for tag information on the iPod is full. Sync the iPod with iTunes and clean up the tagged playlist. Memory full. Tags not stored. This unit's flash memory used as the temporary storage area is full. Connect the iPod to this unit and transfer this unit's tag information to the iPod. Tags transferred failed. This unit's tag in- Check the iPod formation cannot and try again. transfer to the iPod. Tag store failed. Tag information Try again. cannot be stored in this unit. Message Cause Error-8D Built-in FLASH ROM encountered an error SD source can- Tag information not be se- is being trans- lected during ferred to the tag transfer. iPod. Action Turn the ignition OFF and ON. Wait until tag transfer is complete. Bluetooth Message Error-10 Cause Action The power failed for the Bluetooth module of this unit. Turn the ignition switch OFF and then to ACC or ON. If the error message is still displayed after performing the above action, please contact your dealer or an authorized Pioneer Service Station. Understanding auto EQ error messages When correct measurement of the car's interior acoustic characteristics is not possible using auto EQ, an error message may appear on the display. In such cases, refer to the table below to see what the problem is and how it may be corrected. After checking, try again. Message Error. Please check MIC. Cause Action The microphone Plug the optional is not connected. microphone se- curely into the jack. En 77