Pioneer AVH-P3300BT Owner's Manual - Page 69
Touch Auto EQ Measurement to enter
UPC - 884938123341
View all Pioneer AVH-P3300BT manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 69 highlights
Menu operations Section 15 Menu operations 3 Turn the ignition switch to ON or ACC. If the car's air conditioner or heater is turned on, turn it off. Noise from the fan in the air conditioner or heater may prevent correct auto EQ. 4 Display the system menu. Refer to Introduction of menu operations on page 57. 5 Touch Auto EQ Measurement to enter auto EQ measurement mode. 6 Plug the microphone into the microphone input jack on this unit. (AVH-P4300DVD) # To stop auto EQ, touch Stop. # To cancel auto EQ measurement mode during this procedure, touch the following touch panel key. Canceling auto EQ measurement mode. 9 Store the microphone carefully in the glove compartment or another safe place. If the microphone is subjected to direct sunlight for an extended period, high temperatures may cause distortion, color change or malfunction. 10 Press h(eject) to close the panel. (AVH-P4300DVD only) Note (AVH-P4300DVD) Do not press h (eject) to open or close the panel when you are using the microphone. (AVH-P3300BT) 7 Touch Start to start auto EQ. 8 When the 10-second countdown starts, get out of the car and close the door within 10 seconds. A measurement tone (noise) is emitted from the speakers, and auto EQ measurement begins. When auto EQ is completed, Complete is displayed. When the car's interior acoustic characteristics cannot be measured correctly, an error message will be displayed. (Refer to Understanding auto EQ error messages on page 94.) # It takes about nine minutes for auto EQ measurement to be completed when all the speakers are connected. En 69