Pioneer AVHP5000DVD Other Manual

CAUTION

•

PIONEER does not recommend that you

install or service your display yourself.

Installing or servicing the product may

expose you to risk of electric shock or

other hazards. Refer all installation and

servicing of your display to authorized

Pioneer service personnel.

•

Secure all wiring with cable clamps or

electrical tape. Do not allow any bare

wiring to remain exposed.

•

Do not drill a hole into the engine com-

partment to connect the yellow lead of

the unit to the vehicle battery. Engine

vibration may eventually cause the insu-

lation to fail at the point where the wire

passes from the passenger compartment

into the engine compartment. Take extra

care in securing the wire at this point.

•

It is extremely dangerous to allow the

display lead to become wound around

the steering column or gearshift. Be sure

to install the display in such a way that it

will not obstruct driving.

•

Make sure that wires will not interfere

with moving parts of the vehicle, such as

the gearshift, parking brake or seat slid-

ing mechanism.

•

Do not shorten any leads. If you do, the

protection circuit may fail to work prop-

erly.

WARNING

LIGHT GREEN LEAD AT POWER CONNEC-

TOR IS DESIGNED TO DETECT PARKED

STATUS AND MUST BE CONNECTED TO

THE POWER SUPPLY SIDE OF THE PARK-

ING BRAKE SWITCH. IMPROPER CONNEC-

TION OR USE OF THIS LEAD MAY VIOLATE

APPLICABLE LAW AND MAY RESULT IN

SERIOUS INJURY OR DAMAGE.

WARNING

•

To avoid the risk of accident and the potential vio-

lation of applicable laws, the front DVD or TV

(sold separately) feature should never be used

while the vehicle is being driven. Also, Rear

Displays should not be in a location where it is a

visible distraction to the driver.

•

In some countries or states the viewing of

images on a display inside a vehicle even by

persons other than the driver may be illegal.

Where such regulations apply, they must be

obeyed and this unit’s DVD features should

not be used.

INSTALLATION MANUAL

MANUEL D’INSTALLATION

<KMINX> <07K00000>

AVH-P5000DVD

Printed in Thailand

Imprimé en Thaïlande

<CRD4275-A/N> UC

Connecting the Units

ENGLISH

Note:

•

This unit cannot be installed in a vehicle with-

out ACC (accessory) position on the ignition

switch.

•

Use this unit in other than the following condi-

tions could result in fire or malfunction.

—

Vehicles with a 12-volt battery and negative

grounding.

—

Speakers with 50 W (output value) and 4 ohm

to 8 ohm (impedance value).

•

To prevent short-circuit, overheating or malfunc-

tion, be sure to follow the directions below.

—

Disconnect the negative terminal of the battery

before installation.

—

Secure the wiring with cable clamps or adhe-

sive tape. To protect the wiring, wrap adhesive

tape around them where they lie against metal

parts.

—

Place all cables away from moving parts, such

as gear shift and seat rails.

—

Place all cables away from hot places, such as

near the heater outlet.

—

Do not pass the yellow cable through a hole

into the engine compartment to connect to a

battery.

—

Cover any disconnected cable connectors with

insulating tape.

—

Do not remove RCA caps if RCA cables are

not used.

—

Do not shorten any cables.

—

Never cut the insulation of the power cable of

this unit in order to share the power to other

equipment. Current capacity of the cable is

limited.

—

Use a fuse of the rating prescribed.

—

Never wire the speaker negative cable directly

to ground.

—

Never band together multiple speaker’s nega-

tive cables.

•

Control signal is output through blue/white cable

when this unit is powered on. Connect it to an

external power amp’s system remote control or

the vehicle’s auto-antenna relay control terminal

(max. 300 mA, 12 V DC). If the vehicle is

equipped with a glass antenna, connect it to the

antenna booster power supply terminal.

•

Never connect blue/white cable to external power

amp’s power terminal. Also, never connect it to

the power terminal of the auto antenna.

Otherwise, battery drain or malfunction may

result.

•

IP-BUS connectors are color-coded. Be sure to

connect connectors of the same color.

•

Black cable is ground. This cable and other prod-

uct’s ground cable (especially, high-current prod-

ucts such as power amp) must be wired separate-

ly. Otherwise, fire or malfunction may result if

they are accidentally detached.

No ACC position

ACC position

O

N

S

T

A

R

T

O

F

F

A

C

C

O

N

S

T

A

R

T

O

F

F

Parts supplied

Screw (2 mm

×

5 mm)

(2 pcs.)

Holder

Touch panel pen

Double-ended screw

Rubber bush

Side bracket (large)

(2 pcs.)

Concealing tape

Binding screw

(4 mm

×

3 mm)

(4 pcs.)

Binding screw

(5 mm

×

6 mm)

(4 pcs.)

Flush surface screw

(5 mm

×

6 mm) (6 pcs.)

(2 are pre-installed.)

Screw (2 mm

×

3 mm)

(4 pcs.) (pre-installed)

Side bracket (small)

(2 pcs.) (pre-installed)

Trim ring

(pre-installed)

Mounting sleeve

(pre-installed)

USB cable

Antenna cable

Power cord

Tuner box

This product

Pioneer AVHP5000DVD Other Manual

Pioneer AVHP5000DVD - DVD Player With LCD monitor Manual

Pioneer AVHP5000DVD manual content summary: