Pioneer AVIC-X930BT Owner's Manual - Page 178
Before operating the Auto EQ function, Performing Auto EQ
UPC - 884938127097
View all Pioneer AVIC-X930BT manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 178 highlights
Chapter 32 Customizing preferences Before operating the Auto EQ function ! Perform Auto EQ in as quiet a place as possible, with the vehicle engine and air conditioning switched off. Also, cut power to car phones or cellular phones in the vehicle, or remove them from the vehicle before performing Auto EQ. Sounds other than the measurement tone (surrounding sounds, engine sound, telephones ringing, etc.) may prevent correct measurement of the vehicle's acoustics. ! Be sure to perform Auto EQ using the microphone for acoustical measurement (sold separately). Using another microphone may prevent measurement, or result in incorrect measurement of the vehicle's acoustics. ! To perform Auto EQ, the front speakers must be connected. ! When this navigation system is connected to a power amp with input level control, Auto EQ may not be able to be performed if the power amp's input level is set below the standard level. ! When this navigation system is connected to a power amp with an LPF, turn the LPF off before performing Auto EQ. Also, set the cut-off frequency for the built-in LPF of an active subwoofer to the highest frequency. ! The distance has been calculated by computer to provide the optimum delay to ensure accurate results. Do not change this value. - The reflected sound within the vehicle is strong and delays occur. - The LPF on active subwoofers or external amps delay the lower sounds. ! If an error occurs during measurement, a message appears and measurement is canceled. Check the following before measuring the vehicle's acoustics. - Front speakers (left/right) - Rear speakers (left/right) - Noise - Microphone for acoustical measurement (sold separately) - Low battery Performing Auto EQ p Auto EQ changes the audio settings as follows: ! "Auto EQ" on the "EQ Menu" screen is set to "On". = For details, refer to Using the auto-adjusted equalizer on the previous page. ! The fader/balance settings return to the center position. = For details, refer to Using balance adjustment on page 175. ! The equalizer curve switches to "Flat". = For details, refer to Using the equalizer on page 175. ! The front and rear speakers will automatically be adjusted to a high pass filter setting. p Previous settings for Auto EQ will be overwritten. p For AVIC-Z130BT users Do not press the h button to open or close the panel when you are using the microphone. 1 Stop the vehicle in a place that is quiet, close all the doors, windows and sun roof, and then turn the engine off. If the engine is left running, engine noise may prevent correct Auto EQ. p If driving restrictions are detected during measurement, measurement is canceled. 2 Fix the microphone for acoustical measurement (sold separately) in the center of the headrest of the driver's seat, facing forward. The Auto EQ may differ depending on where you place the microphone. If desired, place the microphone on the front passenger seat and perform Auto EQ. 178 En