Pioneer AVIC-X930BT Owner's Manual - Page 194

Appendix Appendix Symptom Cause Action (Reference) You cannot position your vehicle Something covers the GPS antenna. Do not cover the GPS antenna with spray on the map without a significant paint or vehicle wax, because this may block positioning error. the reception of GPS signals. Snow buildup can also degrade the signals. Signals from the vehicle's speed Check that the cables are properly connected. pulse are not being picked up prop- If necessary, consult the dealer that installed erly. the system. The navigation system may not be mounted securely in your vehicle. Check that the navigation system is securely mounted and, if necessary, consult the dealer that installed the system. The navigation system is installed with an extreme angle exceeding the installation angle limitations. Confirm the installation angle. (The navigation system must be installed within the allowed installation angle. For details, refer to Installation Manual.) Indication of the position of your vehicle is misaligned after a U-turn or reversing. Check whether or not the reverse gear signal input lead (violet) is connected properly. (The navigation system works properly without the lead connected, but positioning accuracy will be adversely affected.) "Eco Graph" is not available. The navigation system is unable to obtain past average fuel mileage data, so "Eco Graph" cannot be displayed. Drive about 10 km on a road without obstructions. Then park your vehicle in a safe place, turn off the navigation system and turn the power to the navigation system back on. The map color does not switch "Day/Night Display" is set to automatically between daytime "Day". and nighttime. Check "Day/Night Display" setting and make sure "Automatic" is selected. (Page 161) The orange/white lead is not connected. Check the connection. The screen is too bright. Picture quality adjustment of the display is not correct. Adjust the picture quality. (Page 169) The display is very dim. The vehicle's light is turned ON, and Read about "Day/Night Display" setting "Automatic" is selected on "Day/ and, if desired, select "Day". (Page 161) Night Display". Picture quality adjustment of the display is not correct. Adjust the picture quality. (Page 169) No sounds of AV source are pro- The volume level is low. duced. The volume level will not rise. The attenuator or mute is on. A speaker lead is disconnected. Adjust the volume level. Turn the attenuator or mute off. Check the connection. The volume of navigation gui- VOL (+/-) button or Multi-control is Turn the volume up or down using "Volume" dance and beeps cannot be ad- used to adjust the volume. on the "System Settings" menu. (Page 165) justed. The person on the other end of the phone call cannot hear the conversation due to an echo. The voice from the person on the Use the following methods to reduce the other end of the phone call is output echo: from the speakers and then picked -Lower the volume on the receiver up by the microphone again, creat- -Have both parties pause slightly before ing an echo. speaking 194 En