Pioneer DDJ-T1 Owner's Manual - Page 6

Using the LAPTOP DOCK, Using with the feet removed - dj

Page 6 highlights

 Removing the power plug While pressing the [PUSH] button on the AC adapter unit, slide the power plug away from the adapter as shown on the diagram below to remove it. Once the power plug is mounted, there is no need to remove it. Using the LAPTOP DOCK The computer's keyboard section can be stowed under this unit. PUSH PUSH Power plug The power plug shown below is included with this product. ! Depending on the size of your (notebook) computer, the keyboard section may not fit in the LAPTOP DOCK. ! Install in such a way that the computer unit does not touch this unit. ! Install in such a way that the cables connected to the computer are not stuck under this unit. Using with the feet removed This unit's two feet can be removed. Use a Phillips screwdriver to remove the screws from the left and right feet (2 screws each). DJ CONTROLLER DDJ-T1 ! The screws you have removed will be needed when mounting the feet. Be careful not to lose them. The feet cannot be properly mounted using other screws. 6 En

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32

En
6
±
Removing the power plug
While pressing the [PUSH] button on the AC adapter
unit, slide the power plug away from the adapter as
shown on the diagram below to remove it.
Once the power plug is mounted, there is no need to remove it.
PUSH
PUSH
Power plug
The power plug shown below is included with this product.
Using the LAPTOP DOCK
The computer’s keyboard section can be stowed under this unit.
!
Depending on the size of your (notebook) computer, the keyboard
section may not fit in the LAPTOP DOCK.
!
Install in such a way that the computer unit does not touch this unit.
!
Install in such a way that the cables connected to the computer are
not stuck under this unit.
Using with the feet removed
This unit’s two feet can be removed.
Use a Phillips screwdriver to remove the screws from the
left and right feet (2 screws each).
DJ CONTROLLER
DDJ-T1
!
The screws you have removed will be needed when mounting
the feet. Be careful not to lose them. The feet cannot be properly
mounted using other screws.