Pioneer DEH-P3100UB Owner's Manual - Page 26

Section 04 Initial Settings Adjusting initial settings 1 Press SRC and hold until the unit turns off. 2 Press MULTI-CONTROL and hold until CLOCK SET appears in the display. 3 Turn MULTI-CONTROL to select one of the initial settings. CLOCK SET (clock)-AUX1 (auxiliary input 1) -AUX2 (auxiliary input 2)-SW CONTROL (rear output and subwoofer controller)- EVER SCROLL (ever scroll)-BT AUDIO (Bluetooth audio)-PIN CODE INPUT (pin code input)-BT VER INFO (Bluetooth version information) # You can also perform the same operations by pushing MULTI-CONTROL up or down. # To cancel initial settings, press BAND/ESC. # BT AUDIO, PIN CODE INPUT and BT VER INFO can be selected only when Bluetooth adapter (e.g., CD-BTB200) is connected to this unit. Setting the clock Use these instructions to set the clock. 1 Use MULTI-CONTROL to select CLOCK SET in the initial setting menu. Refer to Adjusting initial settings on this page. 2 Press MULTI-CONTROL to display the setting mode. # Press DISP/BACK/SCRL to return to the previous display. 3 Press MULTI-CONTROL to select the segment of the clock display you wish to set. Each time you press MULTI-CONTROL, one segment of the clock display is selected. Hour-Minute As you select segments of the clock display, the selected segment blinks. 4 Turn MULTI-CONTROL to put a clock right. # You can also perform the same operations by pushing MULTI-CONTROL up or down. Switching the auxiliary setting Auxiliary devices connected to this unit can be activated individually. Set each AUX source to ON when using. For more information about connecting or using auxiliary devices, refer to Using the AUX source on page 29. 1 Use MULTI-CONTROL to select AUX1/ AUX2 in the initial setting menu. Refer to Adjusting initial settings on this page. 2 Press MULTI-CONTROL to turn AUX1/ AUX2 on. # To turn AUX off, press MULTI-CONTROL again. Setting the rear output and subwoofer controller This unit's rear output (rear speaker lead output and RCA rear output) can be used for fullrange speaker (REAR SP :FULL/ PREOUT :REAR) or subwoofer (REAR SP :SUB W/PREOUT :SUB W) connection. If you switch the rear output setting to REAR SP :SUB W, you can connect a rear speaker lead directly to a subwoofer without using an auxiliary amp. Initially, the unit is set for rear full-range speaker connection (REAR SP :FULL). When rear output is connected to full range speakers (when REAR SP :FULL is selected), you can connect the RCA subwoofer output to a subwoofer. In this case, you can select whether to use the subwoofer controller's (low pass filter, phase) built-in PREOUT :SUB W or the auxiliary PREOUT :REAR. 26 En