Pioneer FH-P8000BT Other Manual - Page 5
Installation, English
UPC - 012562886664
View all Pioneer FH-P8000BT manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 5 highlights
Installation English Note • Check all connections and systems before final installation. • Do not use unauthorized parts. The use of unauthorized parts may cause malfunctions. • Consult with your dealer if installation requires drilling of holes or other modifications of the vehicle. • Do not install this unit where: - it may interfere with operation of the vehicle. - it may cause injury to a passenger as a result of a sudden stop. • Do not install the display where it may (i) obstruct the driver's vision, (ii) impair the performance of any of the vehicle's operating systems or safety features, including air bags, hazard lamp buttons or (iii) impair the driver's ability to safely operate the vehicle. • The semiconductor laser will be damaged if it overheats. Install this unit away from hot places such as near the heater outlet. • Optimum performance is obtained when the unit is installed at an angle of less than 60°. • To some types of vehicles, this unit cannot be properly installed. In such case, use the optional installation kit (ADT-VA133). • When installing, to ensure proper heat dispersal when using this unit, make sure you leave ample space behind the rear panel and wrap any loose cables so they are not blocking the vents. Leave ample space Dashboard 5cm 10cm Installation using the screw holes on the side of the unit Fastening the unit to the factory radio-mounting bracket. Position the unit so that its screw holes are aligned with the screw holes of the bracket, and tighten the screws at 3 or 4 locations on each side. If the pawl gets in the way, bend it down. Factory radio mounting bracket Binding screw or flush surface screw Be sure to use the screws supplied with this unit. Dashboard or console Note In some types of vehicles, discrepancy may occur between the unit and the dashboard. If this happens, use the supplied frame to fill the gap. Installation Installing the microphone Installation notes Install the microphone in a position and orientation that will enable it to pick up the voice of the person operating the system. CAUTION It is extremely dangerous to allow the microphone lead to become wound around the steering column or gearstick. Be sure to install the unit in such a way that it will not obstruct driving. When installing the microphone on the sun visor 1. Install the microphone on the microphone clip. English 2. Install the microphone clip on the sun visor. With the sun visor up, install the microphone clip. (Lowering the sun visor reduces the recognition rate for voice operations.) Microphone clip Clamps Use clamps to secure the lead where necessary inside the vehicle. Microphone Microphone clip When installing the microphone on the steering column 1. Install the microphone on the microphone clip. Microphone Microphone clip Fit the microphone lead into the groove. Installation 2. Install the microphone clip on the steering column. Double-sided tape Install the microphone clip on the rear side of the steering column. Clamps Use clamps to secure the lead where necessary inside the vehicle. Adjusting the microphone angle The microphone angle can be adjusted by moving forward or backward the microphone clip angle. English