Pioneer MVH-P8200BT Installation Manual - Page 3

Connecting the unit Connecting the power cord This product English Antenna input Fuse (10 A) IP-BUS input (Blue) IP-BUS cable Yellow Connect to the constant 12 V supply terminal. Orange/white Connect to lighting switch terminal. Red Connect to terminal controlled by ignition switch (12 V DC). Fuse resistor Fuse resistor Black (chassis ground) Connect to a clean, paint-free metal location. � Front speaker � Left Rear speaker or � Subwoofer (4 Ω) � White Gray White/black Green Gray/black Violet Green/black Violet/black � Front speaker � Right � Rear speaker or � Subwoofer (4 Ω) When using a subwoofer of 70 W (2 Ω), be sure to connect with Violet and Violet/black leads of this unit. Do not connect anything to Green and Green/black leads. Not used. Green Green/black Violet Violet/black � Subwoofer (4 Ω) × 2 � Connecting the unit Microphone input (MVH-P8200BT only) 4 m (13 ft. 1 in.) Microphone (MVH-P8200BT only) Wired remote input Hard-wired remote control adaptor can be connected (sold separately). Pioneer IP-BUS accessories (sold separately) English Connection method 1. Clamp the lead. 2. Clamp firmly with needle-nosed pliers. Note: · The position of the parking brake switch depends on the vehicle model. For details, consult the vehicle Owner's Manual or dealer. Light green Used to detect the ON/OFF status of the parking brake. This lead must be connected to the power supply side of the parking brake switch. Power supply side Ground side Blue/white Connect to system control terminal of the power amp or auto-antenna relay control terminal (max. 300 mA 12 V DC). With a 2 speaker system, do not connect anything to the speaker leads that are not connected to speakers. Parking brake switch Note: · Change the initial setting of this unit (refer to the Operation Manual). The subwoofer output of this unit is monaural. Connecting the unit When connecting to separately sold power amp English Rear output This product Front output Subwoofer output To rear output To front output To subwoofer output Power amp (sold separately) Power amp (sold separately) Power amp (sold separately) Connect with RCA cables (sold separately) Blue/white Connect to system control terminal of the power amp or auto-antenna relay control terminal. (max. 300 mA 12 V DC). System remote control Left Right � Subwoofer � � Subwoofer � � Front speaker � � Rear speaker Perform these connections when � using the optional amplifier. � Front speaker � � Rear speaker �