Pioneer SD-643HD5 Operating Instructions - Page 66

REMOTE CODE SET UP TV CBL VCR DVD TV /SAT /LD /DTV TV ANT INPUT 1 2 3 4 FREEZE SCREEN MODE SPLIT SWAP SEARCH SELECT SUB CH DISPLAY SLEEP 123 456 789 0 CH ENTER ¢ CH RETURN CH MUTING 4 VOL EDIT/ LEARN SOURCE POWER TV/SAT/DVD MENU 5 DTV/DVD TOP MENU DTV/SAT GUIDE 2 SET/ ENTER 3 DTV/(SAT) 8 ∞ INFO FAVORITE CH VCR REC 1 7 3 ¡ RECEIVER INPUT VOL VOL Î HDTV PROJECTION MONITOR NOTES: • To stop the EDIT mode in the middle, press the EDIT button once more. • If mode switch is switched while in EDIT mode, EDIT mode will be canceled. • After step 1 and step 2, if you do not press the button for one minute (no operation), the EDIT mode will be canceled. • If the table on page 67 does not include your desired manufacturer or the remote control code does not work, you can make the memory learn its code by the learning mode (see page 68). • The initial code is "00" (PIONEER). 66 To operate other manufacturers' audio/video units using this remote control unit, remote control codes need to be input. There are two methods of setting remote control codes • For calling the other manufacturers' preset remote control codes to this remote control unit • For learning other manufacturers' remote control codes RECALLING OTHER MANUFACTURERS' PRESET REMOTE CONTROL CODES 1 Setthemodeswitchtomatchthedevice to which you want to preset the remote control code. • Example: To select DVD/LD. TV CBL VCR DVD /SAT /LD /DTV |\ 2 At the same time, press the EDIT button and number button 1. LED will begin blinking. EDIT/ LEARN 1 TV CBL VCR DVD TV /SAT /LD /DTV TV ANT INPUT 1 2 3 4 3 Select the desired manufacturer. • Select from the figure on page 67. • Example: To select 24 (PHILIPS) in the LD mode. 2 4 • If the LED blinks rapidly when the number button has been pressed, there has been an error. Input the number again. • After setting, you can automatically use the remote control in the usual manner.