Pioneer VSX-43 Owner's Manual - Page 67

11 Additional information Specifications Amplifier section Continuous average power output of 80 watts* per channel, min., at 8 ohms, from 20 Hz to 20 000 Hz with no more than 0.08 %** total harmonic distortion. Front (stereo 80 W + 80 W Guaranteed speaker impedance 6  to 16  * Measured pursuant to the Federal Trade Commission's Trade Regulation rule on Power Output Claims for Amplifiers ** Measured by Audio Spectrum Analyzer Audio Section Input (Sensitivity/Impedance) LINE 200 mV/47 k Signal-to-Noise Ratio (IHF, short circuited, A network) LINE 98 dB Signal-to-Noise Ratio [EIA, at 1 W (1 kHz)] LINE 79 dB Video Section Signal level Composite 1 Vp-p (75 ) Signal Level Component Video Y: 1.0 Vp-p (75 ), PB/PR: 0.7 Vp-p (75 ) Corresponding maximum resolution Component Video 1080p (1125p) Tuner Section Frequency Range (FM 87.5 MHz to 108 MHz Antenna Input (FM 75  unbalanced Frequency Range (AM 530 kHz to 1700 kHz Antenna (AM Loop antenna Digital In/Out Section HDMI terminal Type A (19-pin) HDMI output type 5 V, 100 mA HDMI input/MHL terminal 5 V, 900 mA USB terminal USB2.0 High Speed (Type A) 5 V, 2.1 A iPod terminal USB, and Video (Composite) ADAPTER PORT terminal 5 V, 100 mA Network Section LAN terminal 10 BASE-T/100 BASE-TX Integrated control section Control (IR) terminal 3.5 Mini-jack (MONO) IR signal High Active (High Level: 2.0 V) 12 V Trigger terminal 3.5 Mini-jack (MONO) 12 V Trigger output type 12 V, 150 mA Miscellaneous Power Requirements AC 120 V, 60 Hz Power Consumption 520 W In standby 0.1 W 0.3 W (HDMI Setup - Control : ON) Dimensions . . . . . 435 mm (W) x 168 mm (H) x 342.5 mm (D) 171/8 in. (W) x 65/8 in. (H) x 131/2 in. (D) Weight (without package 9.3 kg (20 lb 9 oz) Furnished Parts Microphone (for Auto MCACC setup 1 Remote control 1 Dry cell batteries (AAA size IEC R03 2 AM loop antenna 1 FM wire antenna 1 Warranty card 1 Quick start guide 1 Safety Brochure 1 These operating instructions (CD-ROM) Note • Specifications and the design are subject to possible modifications without notice, due to improvements. • This product includes FontAvenue® fonts licensed by NEC Corporation. FontAvenue is a registered trademark of NEC Corporation. The Safety of Your Ears is in Your Hands Get the most out of your equipment by playing it at a safe level - a level that lets the sound come through clearly without annoying blaring or distortion and, most importantly, without affecting your sensitive hearing. Sound can be deceiving. Over time, your hearing "comfort level" adapts to higher volumes of sound, so what sounds "normal" can actually be loud and harmful to your hearing. Guard against this by setting your equipment at a safe level BEFORE your hearing adapts. ESTABLISH A SAFE LEVEL: • Set your volume control at a low setting. • Slowly increase the sound until you can hear it comfortably and clearly, without distortion. • Once you have established a comfortable sound level, set the dial and leave it there. BE SURE TO OBSERVE THE FOLLOWING GUIDELINES: • Do not turn up the volume so high that you can't hear what's around you. • Use caution or temporarily discontinue use in potentially hazardous situations. • Do not use headphones while operating a motorized vehicle; the use of headphones may create a traffic hazard and is illegal in many areas. S001a_A1_En 4 7 62 67