Pioneer VSX-522-K Owner's Manual - Page 11
Analog, Audio - no sound
View all Pioneer VSX-522-K manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 11 highlights
2 Connecting your equipment Connecting the speakers The receiver will work with just two stereo speakers (the front speakers in the diagram) but using at least three speakers is recommended, and a complete setup is best for surround sound. Make sure you connect the speaker on the right to the right (R) terminal and the speaker on the left to the left (L) terminal. Also make sure the positive and negative (+/-) terminals on the receiver match those on the speakers. You can use speakers with a nominal impedance between 6 Ω and 16 Ω. Be sure to complete all connections before connecting this unit to the AC power source. Bare wire connections Front speaker terminals: 1 2 3 1 Twist exposed wire strands together. 2 Loosen terminal and insert exposed wire. 3 Tighten terminal. 10 mm (3/8 in.) Center and surround speaker terminals: 1 2 3 1 Twist exposed wire strands together. 2 Push open the tabs and insert exposed wire. 3 Release the tabs. 10 mm (3/8 in.) CAUTION • These speaker terminals carry HAZARDOUS LIVE voltage. To prevent the risk of electric shock when connecting or disconnecting the speaker cables, disconnect the power cord before touching any uninsulated parts. • Make sure that all the bare speaker wire is twisted together and inserted fully into the speaker terminal. If any of the bare speaker wire touches the back panel it may cause the power to cut off as a safety measure. Connect the surround back or front height speakers Connect the PRE OUT SURR BACK/FRONT HEIGHT outputs of the unit and additional amplifier to add a surround back or front height speaker. • The Pre Out setting must be set if the above connections are performed. Select Surr.Back if the surround back speaker is connected and Height if the front height speaker is connected (If neither the surround back speaker nor the front height speaker is connected, either setting will suffice) (see The Pre Out Setting on page 33). • You can use the additional amplifier on the surround back channel pre-outs for a single speaker as well. In this case plug the amplifier into the left (L (Single)) terminal only. Subwoofer Front right LINE LEVEL INPUT Center Front left HDMI IN IN OUT ASSIGNABLE DVD SAT/CBL GAME PREOUT IN 1 IN 1 ASSIGNABLE BSDUBWOOFOEP(RTTVIC)AL (CD) COAXIAL PRE OUT SUB WOOFER MONITOR SAT/CBL DVD OUT IN IN VIDEO SURR BACK/ L FRONT HEIGHT (Single) PRE OUT ANTENNA R AM LOOP PREOUT L SURR BACK/ IN FRONT HREIGHT R FRONT L CENTER SURROUND R L DVD SAT/CBL ANALOG IN 1 (CD) ASSIGNABLE FM UNBAL 75 AUDIO FRRONLT CENTER SURRROULND Class2Wiring SPEAKERS A CAUTION: ATTENTION: SPEAKER IMPEDANCE ENCEINTE D'IMPEDANCE DE 6 -16 . 6 -16 . Surround right Surround left Surround back or front height speakers Right Left R L ANALOG AUDIO IN R SPEAKER Surround back or front height channel amplifier L SPEAKER 11